Radial Engineering Jensen Twin-Servo handleiding

Niet gecategoriseerd

Radial Engineering

12 pagina's

PDF beschikbaar

Handleiding

Radial Engineering Ltd.

Jensen Twin-Servo 500™ Module

True to the Music

-12 -9

-3

-6

+12 +18

Made in Canada

OUTPUT LEVEL-VU

HPF

48V

PAD

180º

JENSEN TWIN

SERVO

28dB

OMNIPORT: INSTRUMENT INPUT

Radial

990

opamp

FeATUre SeT

1. 10 SeGmenT meTer: Custom designed cir-

cuit for greater VU meter accuracy.

2. GAIn ConTrol: Dual gang pot simultane-

ously controls the dual 990 op-amp topology

for optimal gain at all settings. Stepped attenu-

ation allows for easy recall of settings.

3. 180°: Reverses pins-2 and 3 at the output to

help phase align microphones when two chan-

nels are in stereo use.

4. hIGh PASS FIlTer (hPF): Gentle high-pass

 lter may be inserted into the signal path to

reduce excessive low frequency content and

control resonance.

5. PAD: Reduces the input sensitivity by -15dB

when amplifying exceedingly high output

sources.

6. 48V: Activates the 48V phantom power supply

for use with condenser microphones and ac-

tive direct boxes.

7. ComBo InPUT: Combination balanced XLR

mic input and 1/4” instrument input is mounted

on front panel for ease of use.

8. omnIPorT: Available when used with the

Radial Workhorse, the Omniport accesses a

hi-Z instrument input.

9. JenSen DUAl 990 oPAmPS: 100% discrete

audio signal path without any tone shifting ca-

pacitors.

10. JenSen oUTPUT TrAnSFormer: The JT-

11-EM is linear from 2Hz~200kHz with less

than 0.001% distortion at 20Hz.

11. GroUnD lIFT: Set and forget rear panel

ground switch lifts the pin-1 ground at the XLR

input.

12. JenSen mIC InPUT TrAnSFormer: The

JT-16-PCJR is exceptionally quiet and linear

from 5Hz~50kHz with less than 0.06% distor-

tion at 20Hz.

10 11

Bekijk gratis de handleiding van Radial Engineering Jensen Twin-Servo, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.