Radial Engineering Classic handleiding
Handleiding
Je bekijkt pagina 5 van 20
1
2
3
4
5
6
7
8
9
DRIVE control: Used to adjust overall amount of input gain &
distortion.
MID BOOST switch: This gives you +7dB & +12dB @ 360Hz. This
allows the guitar to cut through the mix and is especially useful for
soloing.
CONTOUR control: Adjust balance of low & high frequencies in the
“NOTCH” & “FAT” VOICING mode. Hint: start at 12 o’clock position.
VOICING switch: NOTCH position: passive boost coloration of low’s &
high’s. FAT position: passive midrange tight filter.
LOW control: Active ‘post-distortion’ tone control. Boost or cut
±14.5dB @ 100 Hz from 12 o’clock position.
TOP END switch: BRIGHT: +6dB @ 10KHz; FLAT is the
recommended position when the amp’s bright switch is on;
DARK: -6dB @ 3.3KHz, normally used with super bright inputs.
HIGH control: Active ‘post-distortion’ tone control. Boost or cut
±10dB @ 4.3KHz from 12 o’clock position.
LEVEL control: This is used to adjust the output level without alter-
ing any of the tonal characteristics.
FOOTSWITCH: Toggles between effect and True-Bypass. i.e.
when the Tonebone is off, the signal passes straight through without
any effect. An on/off status indicator LED is provided.
6. Tonebone Hot British Function Overview
4
TM
True to the Music
Bekijk gratis de handleiding van Radial Engineering Classic, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Radial Engineering |
| Model | Classic |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5564 MB |
