QuickMill Pathfinder handleiding
Handleiding
Je bekijkt pagina 75 van 96
75
Italiano
English
Français
Deutsch
Factory parameters preset
With the PRESET operation, the TermoPID control unit can be reconfigured with
the default parameters (factory data).
To perform the PRESET, proceed as follows:
- With the termopid disabled. press ▼.
- Power the board.
- When the display shows “prs” release the key.
- Cut-out the power to the board.
The factory data (default) is the following:
F03 - °C
P – 1,0
I – 0,01
D – 2,0
F04 - 0
Alarms
In the case of a sensor failure, on the display the caption A1 is shown: the
adjustment and programming outputs are disabled.
Termopid Setting and Functioning model CAROLA
With this TERMOPID model, the set pont temperature adjustment is through the
position of the micro switch as shown below.
Bekijk gratis de handleiding van QuickMill Pathfinder, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | QuickMill |
| Model | Pathfinder |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12821 MB |
