QuickMill Pathfinder handleiding
Handleiding
Je bekijkt pagina 73 van 96
73
Italiano
English
Français
Deutsch
Factory parameters preset
With the PRESET operation, the TermoPID control unit can be reconfigured with
the default parameters (factory data).
To perform the PRESET, proceed as follows:
- With the termopid disabled. press ▼.
- Power the board.
- When the display shows “prs” release the key.
- Cut-out the power to the board.
The factory data (default) is the following:
F01 - °C
F02 – 6
P1 – 1,5
I1 – 0,0
D1 – 1,5
B1 – 10
P2 – 1,5
I2 – 0,0
D2 – 1,5
B2 – 6
T1 – 95
T2 – 124
E1 – 15
E2 - 0
Alarms
In the case of a sensor failure, on the display the caption A1 (or A3 for the Vetrano
model) is shown: the adjustment and programming outputs are disabled.
In the case of a sensor short circuit, on the display the caption A2 (or A4 for the
Vetrano model) is shown: the adjustment and programming outputs are disabled.
Bekijk gratis de handleiding van QuickMill Pathfinder, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | QuickMill |
| Model | Pathfinder |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12821 MB |
