Quantum Turbo SC handleiding
Handleiding
Je bekijkt pagina 6 van 36
4
A yellow flash indicator [ ] shows the status of flash power.
A steady light means the output is supplying flash or camera
power.
A Blinking indicator shows when high voltage has shut down.
Off indicates no power for that output.
6. FLASH INDICATORS
Symptom
A Flash Cable is connected
but the output indicator is
not lit.
A Flash Cable is connected
to a flash and the output
light blinks for 30 seconds.
The fuel gauge’s 25%
green light blinks for a few
minutes, and then all lights
go out and there is no power
to the equipment connected.
7. ERROR CONDITIONS and TROUBLESHOOTING
Solution
The cable could be broken, shorted, or
it may be the wrong cable.
Turbo SC has detected that no flash is
connected. This could be caused by
an intermittent or broken cable, or a
cable that is not fully engaged in the
socket.
This is the low battery indication.
Recharge. Check that the charger is
connected to a live mains outlet that
cannot be switched off.
Turbo SC may be clipped onto a belt with its
attached belt clip.
The Turbo SC also can be worn over a shoulder
using the shoulder strap. For comfort, the belt clip
may be removed from Turbo SC, as shown in the
diagram.
Loosen the screws a few turns and remove the
belt clip. Do not remove the screws completely!
Re-tighten the screws with moderate pressure.
8. WEARING TURBO SC
TSC INSTRUC trans 8/8/06 8:28 PM Page 6
Bekijk gratis de handleiding van Quantum Turbo SC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Quantum |
| Model | Turbo SC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3276 MB |