QSC QIO-AES8x8 handleiding
Handleiding
Je bekijkt pagina 24 van 26
24
Rack Mount Installation
Q-SYS QIO Endpoints are designed to be mounted in a standard rack-mount unit using the Q-SYS 1RU rack tray (FG-901528-00, QIO-
RMK). The rack tray accommodates up to four quarter-rack width QIO devices or two half-rack width (QIO-FLEX4A) devices. A QIO-
FLEX4A unit can occupy the left, right, or center of the tray.
Rack Tray Hardware
(1x)
Rack
mounting
tray
(3x)
Blanking plates
(14x)
M3 x 6 mm flat
head screws
(4x)
Retaining clips
Attach the Retaining Clips
For each QIO Endpoint you are installing in the tray, insert and attach a retaining clip in either the short (5.5”) or long (8.5”) length location
using a flat head screw.
Short Length
Long Length
Attach the QIO Endpoints and Blanking Plates
Slide each QIO Endpoint into a retaining clip. Attach each unit with two flat head screws. Optionally attach the blanking plates, each with
two flat head screws.
NOTE: Blanking plates are optional and can be used to facilitate proper rack airflow. Unused blanking plates can be
attached at the rear of the tray if needed, as shown.
Bekijk gratis de handleiding van QSC QIO-AES8x8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | QSC |
| Model | QIO-AES8x8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2811 MB |
