Promise Technology VESS A3340S Handleiding (243 Pagina's)

Handleiding

/ 243

Je bekijkt pagina 116 van 243

105

Managing with WebPAM PROeVess A3340s / Vess A3340d / Vess A3340 PoE

Rebuild Settings

To change Rebuild setting the in Background Activities Settings menu:

1. Use the Rebuild Rate drop-down menu to choose a rate:

• Low–FewersystemresourcestotheRebuild,moretodataread/writeoperations.

• Medium–Balancessystemresourcesbetweenthe

Rebuildanddataread/writeoperations.

• High–MoresystemresourcestotheRebuild,fewertodataread/writeoperations.

2. To enable Auto Rebuild (rebuilds when you swap out the failed drive with a new one) Check the Enable

Auto Rebuild box.

3. Click the Submit button.

Rebuild Rate

When you rebuild a disk array, you are actually rebuilding the data on one physical drive.

• When a physical drive in a disk array fails and a spare drive of adequate capacity is available, the disk array

begins to rebuild automatically using the spare drive.

• If there is no spare drive of adequate capacity, but the Auto Rebuild function is ENABLED, the disk array

begins to rebuild automatically as soon as you remove the failed physical drive and install an uncongured

physical drive in the same slot.

• If there is no spare drive of adequate capacity and the Auto Rebuild function is DISABLED, you must

replace the failed drive with an uncongured physical drive, then perform a Manual Rebuild.

Background Synchronization

Synchronization is automatically applied to redundant logical drives when they are created. Synchronization

recalculates the redundancy data to ensure that the working data on the physical drives is properly in sync.

/ 243

Bekijk gratis de handleiding van Promise Technology VESS A3340S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.