Proficare PC BS 3037 A handleiding
Handleiding
Je bekijkt pagina 49 van 86
PC-BS3037A_IM 27.05.19
49
• You may attach this brush both directly onto the connec-
tion on the handset as well as onto the connection of the
already mounted suction pipe.
• To release the nozzle, simply pull it off.
Assembly the Wall Holder
Please take a look at Figures C and D on page 3.
Inserting the Plug of the Power Adapter
If you want to use the wall holder also as the charging sta-
tion, attach the plug of the power adapter rst (Fig. C)
1. Connect the power supply plug to the slot on the back of
the charging unit.
2. Firmly push the plug into the terminals. It must audibly
snap into place.
3. Secure the cable in the right or left cable guide.
Fastening the Wall Holder
WARNING:
Make sure beforehand whether there are cables in the
wall which could be damaged!
CAUTION:
Place the wall holder so that the appliance is not exposed
to direct sunlight or other heat sources.
NOTE:
If you would like to simultaneously use the wall mount as
a charging station, there must be a power outlet nearby.
1. Measure the height for the wall holder. Hold the vacuum
cleaner against the wall with the suction pipe and the
oor nozzle installed.
2. Hold the wall holder against the wall as shown on page 3
(Fig. D). Mark 2 drill holes.
3. Drill the holes and insert the wall plugs into the wall.
4. Insert the screws through the holes of the wall holder.
5. Tighten the screws with a screwdriver hand-tight.
Charging the Rechargeable Battery
CAUTION:
Do not charge the rechargeable battery unsupervised.
1. Turn off the appliance.
2. Connect the power adapter with the connection
socket (10). If you have prepared the wall holder as a
charging station, suspend the appliance from the wall
holder.
3. Connect the power adapter to a certied wall socket.
Charge the appliance for approx. 5 hours before rst-
time use.
NOTE:
• The indicator lights show the state of charge of the
rechargeable battery. (25 %, 50 %, 100 %)
• The appliance has electronic charge control, which
prevents overcharging.
• Charging is completed when all 3 indicator lights
are lit.
• In case the appliance is removed from the charging
station or disconnected from the power adapter, the
indicator lights go out.
• It is normal for the appliance to heat up during
charging.
4. Disconnect the power
adapter from the outlet once
the rechargeable battery has
been charged completely.
5. To remove the appliance
from the charging station,
press the release latch on top
of the wall mount.
NOTE:
Even when switched off,
the rechargeable battery
discharges continuously. If the
appliance is out of use for a
longer period of time, charge
the rechargeable battery at
least once every 4 to 6 weeks.
Using the Appliance
You can use the appliance as a oor vacuum cleaner or as
a handheld and upright vacuum cleaner (basic unit).
1. Disconnect the appliance from the power adapter.
2. Turn on the appliance.
3. If you would like to tilt the suction pipe at the joint, press
the release (14).
NOTE:
• We recommend the higher power level for using the
appliance with the oor nozzle. Press the MAX button.
• During operation, depending on the charging capacity
of the rechargeable battery, 1 to 3 indicator are lit.
• We recommend recharging the battery once the indica-
tor lights show a remaining capacity of only 25 %.
• Once the capacity of the rechargeable battery is al-
most reaching its end, the last indicator light will ash.
To avoid a deep discharge of the rechargeable battery,
the motor will shut off the appliance accordingly. Re-
charge the battery.
End of Operation
1. Turn off the appliance.
2. If you have already installed the wall holder, hang up the
vacuum cleaner.
Maintenance
The Filter System
Your appliance features 3 lters. The common dust bag
system has been replaced by a transparent dust collector.
The higher ow speed of the collector allows for heavy dirt
and smallest oating particles to be separated from the
“sucked-in air”.
It is thus not necessary to buy dust bags.
The lters must be cleaned periodically.
CAUTION:
• Never wash the lter in the washing machine.
• Do not use a hairdryer for drying.
• Only put the appliance back into operation when all
lters are completely dry and correctly assembled.
The Filter Unit
The lter unit is composed of:
• Fine material lter
• Coarse lter
Proceed as follows to clean
the lter unit:
Emptying the Dust Collector
1. Disconnect the appliance from the power adapter.
2. If necessary, remove the suction tube or the nozzle
attachment from the appliance.
3. Please take a look at Figure A on page 3. Press the
button on the dust container to release it from the
handset.
4. Pull out the ne material lter on the coloured piece of
fabric.
5. Pull out the coarse lter on its handle to remove it from
the dust container.
6. Empty the contents of the dust collector.
Cleaning the Filters
1. Hold both lters over a garbage can and tap out the dust.
You may also brush out the ne material lter. In case of
heavy staining, clean the lters under running water.
2. Let the lters air-dry completely before retting them!
3. Wipe the dust collector with a damp cloth and then wipe
it dry.
Bekijk gratis de handleiding van Proficare PC BS 3037 A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Proficare |
| Model | PC BS 3037 A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12063 MB |
