Proel AE604 handleiding
Handleiding
Je bekijkt pagina 14 van 48
14
USRMAN_AE604EN_REV003
Connect the batteries in series, then wire the resulting stack to the dedicated battery connector that was provided with the unit. Connect this
connector to the “battery DC 48V” input. Be very careful to not short plus and minus wires together, this will result in spreading lots of energy. It
can be harmful to you and can permanently damage the batteries or the AE604 itself. Also, be very careful to respect the polarity as indicated in
the figure below:
Once done, simply plug the cord in the battery input socket. Notice: the unit will power-up only after the mains is applied.
Finally, locate the battery temperature probe and secure it between two adjacent batteries.
Note: In case of detachment of the battery compartment from the device, and the consequent connection with long cables, we recommend
protecting the cables in a special pipe. Insert protection with circuit breaker or fuse or switch of suitable W / A / h value.
4.s Connection to the mains power supply (N: Neutral – L: Line) and earthing
The socket for the 230V mains power supply and earthing connection is located close to battery socket at the bottom of the internal chassis.
Wire the mains and earth to the plug provided with the unit as indicated in the figure below:
ATTENTION: Make the mains and earthing connections as shown in the above figure.
For the connection to the power mains, provide a 6A-C6 circuit breaker dedicated to the equipment; this must be placed in an easily accessible
position.
Use cables with a section of 2.5mm2 for both the mains power supply and earthing.
Make sure that the signal cables, and the low voltage cables in general, do not accidentally touch the mains voltage points. These are the
terminals for connection to the mains voltage, and the areas marked with the symbol inside the device.
Plug the mains cord to its socket with the circuit breaker in the OPEN position. Provide power only after the mains power plug is connected to
the unit.
4.t Powering the system
Close the circuit breaker, and shortly after the system display will indicate “POWER ON” and so begins the switch-on sequence.
4.u Internal clock battery replacement
The battery-holder for the battery of the internal clock and calendar is located on the CPU mainboard. Please refer to qualified personnel for
battery substitution. For best performance and system confidence, the CR2032 battery should be replaced once every 4 years
Bekijk gratis de handleiding van Proel AE604, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Proel |
| Model | AE604 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10950 MB |
