Proel AE300R1 handleiding
Handleiding
Je bekijkt pagina 9 van 48
9
If you do not intend to use the remote activation of messages, you cannot leave these terminals open without the device reporting a fault.
Therefore, connect two resistors 2.2Kohm directly on the mainboard terminal J6 (1-2 and 3-4) so that the device does not signal a connection
fault or a Voice Alarm.
4.g Generic announcement microphone workstation
The system has an input for a microphone workstation for generic announcements, that is not evacuation and voice alarm announcements. The
terminal shown in the figure has a balanced microphone input and a priority contact input.
The microphone input for generic announcements also has +48V phantom power supply that can be activated from the menu. ACCESS AT LEVEL
3 -> OK -> 7 x DOWN -> OK -> 6 x DOWN -> OK -> OK -> LEFT -> DOWN -> OK
J5 – Mic paging input
1 – MIC +
2 – MIC GND
3 – MIC -
4 – Priority
5 – GND Priority
Input for microphone paging workstation for generic announcements. 48V Phantom
power supply that can be activated from menu: common mode on pin 1 and 3 compared
to pin 2.
Power levels: 1.0Vrms max, Ri=600Ohm
Active contact for closure to ground, protected up to +42V compared to GND
Use cable with 0.5 mm min and 2.5 mm max section on priority contact.
Use shielded cable with 0.5 mm min section on audio input.
Note: For this application You can use the following microphone workstations: Code PA BM101 // PA BM102
Bekijk gratis de handleiding van Proel AE300R1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Proel |
| Model | AE300R1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10135 MB |
