Prixton Spire BT300 handleiding
Handleiding
Je bekijkt pagina 20 van 73
CLEAN PAD MAINTENANCE
・ Washing temperature not higher than 40 ºC
・ Do not bleach
・ Do not tumble dry
・ Do not iron
・ Do not dry clean
TROUBLE SHOOTING
Q：When the robot starts, it will run self-inspection first. If it cannot operate normally
and the robotsends out an alarm sound, it indicates that the friction is too large or too
small.
A: Please check the following problems：
（1）The clean pad is too dirty.
（2）Glass or glass stickers have high friction and they are not suitable for use.
（3）When the glass surface is already very clean, the glass will be too slippery and the
friction is too small.
（4）The ambient humidity is too low and the glass will be too slippery.
Q：When pressing the key AUTO to run automatic cleaning mode, the robot cannot
detect the top of the window smoothly due to slipping.
A：（ 1）Please press the key STOP to pause the robot，then press the key or to run
the automatic cleaning mode.
（2）If the water or detergent is sprayed too much, the clean pad is too wet or dirty, please
replace the clean pad.
Q：The robot cannot finish cleaning the windows, or the window cleaning action is ended
in advance.
A：press the key or to redo the unfinished work.
Q：The robot cannot climb up to the top of window.
A：（ 1）The friction is too small.
（2）The clean pad is wet.
（3）When the glass surface is already very clean, the glass will be too slippery. （4）The
ambient humidity is too high and the glass will be too slippery.
Q：The robot does not walk smoothly.
A：（ 1）Check if clean pads are dirty and change for clean ones.
（2）Check if any gaps on the glass.
（3）Check if any stickers on the glass surface.
（4）Check if the screw on the clean wheel is loose, then fasten it.
（5）Check if clean ring securely installed, then install.
Q：There are marks remain on the glass after cleaning.
A：Check if clean pads are dirty. Then change for clean pads and run clean routine again.
Q：The robot stops running due to power failure, make a warning sound, and the LED
flashes red. How to deal with it?
A: （1）Gently pull the robot back with the safety rope. When pulling the safety rope, it
should be close to the glass as far as possible to avoid falling.
（2）Check whether the plugs of the power supply are plugged in properly, whether there is
poor contact or the power cord is disconnected.
（3）Press the power key to restart the robot and double check after finishing step 1 &2.
Q: The robot stops when hitting unknown obstacles, LED flashes red but no alert sound,
how to deal with it?
A: （1）Remote control the robot to a safe position, or gently pull the robot back by safety
rope. When pulling the safety rope, it should be close to the glass to avoid falling.
AUTO
AUTO
AUTO
AUTO
AUTO
20
Bekijk gratis de handleiding van Prixton Spire BT300, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Prixton |
| Model | Spire BT300 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9665 MB |
