PreSonus Worx Control handleiding
Handleiding
Je bekijkt pagina 4 van 35
2
2 Networking Your Loudspeaker
2.1 Adding a Wireless Router to a Dante Network
Worx Control
Software Reference Manual
2 Networking Your Loudspeaker
PreSonus CDL-series loudspeakers and WorxAudio PDA-series amplifiers can connect
directly to a wireless router using an Ethernet cable. If you require more network
connections, a standard Gigabit switch can be employed. Even if you are only
connecting your loudspeaker to a network for control, it is recommended that you
follow the best practices for Dante Networking to prevent networking issues.
If your loudspeaker is connected to a Dante network, there are some best practices
to follow. While Dante is compatible with standard network hardware, there are a
few basic requirements to keep in mind when choosing your network switch. The
following recommendations are based on the needs of a high-channel-count system
(more than 32 channels).
• Non-blocking layer-2 gigabit switch with a packet-forwarding rate of 1.488 Mpps
per port. For example, if you purchase an 8-port switch, the packet-forwarding
rate would have to be 11.904 Mpps (1.488 Mpps x 8).
• Energy Efficient Ethernet (EEE), also known as Green Ethernet or IEEE 802.3az,
reduces power consumption when there isn’t much traffic on the network.
Unfortunately, this can lead to audio interruptions and can degrade clocking. If
your switch provides this feature, make sure that you can and do disable it.
• Managed switches are required if you plan to use Worx Control on your
computer connected wirelessly to remote control your loudspeaker. Managed
switches can also help you create a more stable Dante network if you have a
complicated setup.
• Most managed switches support Quality of Service (QoS). This allows you to
choose Dante clock synchronization as the highest priority and audio data as
the next-highest priority. This is especially important if you are transferring large
amounts of data over your Dante network or if you are transferring non-Dante
data over the same network.
• If you are using multiple switches on your Dante network, we recommend using
the same make and model to simplify setup and guarantee compatibility.
2.1 Adding a Wireless Router to a Dante Network
Dante audio and routing cannot travel over a wireless network. You can still
wirelessly remote control CDL-series loudspeakers and PDA-series amplifiers over a
Dante network using Worx Control but you’ll have to do a little more setup.
To connect a wireless router to your Dante network, you will need to purchase a
managed switch and dive into its configuration settings. Select the port to which
you’ve connected your wireless router and set Multicast Filtering to “On.” This will
stop the flow of Dante traffic to that port and allow it to be used for wireless remote
control of your loudspeakers. Do not connect Dante devices to the ports on a
wireless router. Please consult the documentation that came with your managed
switch for instruction about enabling Multicast Filtering on a specific port.
Because your loudspeakers are hardwired to the switch, no additional setup is
required to remote control them with Worx Control. Simply connect your device to
the wireless router network and launch Worx Control.
Bekijk gratis de handleiding van PreSonus Worx Control, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | PreSonus |
| Model | Worx Control |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4962 MB |
