PreSonus UC Surface handleiding
Handleiding
Je bekijkt pagina 9 van 75
6
2 Mix Controls
2.3 Input Channel Controls
UC Surface
Reference Manual
4. Polarity. This button will illuminate when polarity
is inverted on the current channel.
Power User Tip: The Polarity control inverts the polarity of the selected channel’s
preamp signal by 180°. The Polarity button can be used to correct audio signals that
are out of phase relative to each other, which causes frequency cancellation and
reinforcement. When recording with more than one open microphone, you may
need to invert the polarity to combat phase cancellation between microphones.
5. Phantom Power Enables/disables phantom power
for the currently selected channel.
6. High-Pass Filter. Sets the High-Pass Filter Frequency Threshold for the Selected
Channel or Output Bus. The lter’s threshold can be set from 24 Hz to 1 kHz.
When the meter is set to its lowest point, the lter is o. The high-pass lter is
available on all input channels and on auxiliary and FX output buses only.
Power User Tip: A high-pass lter attenuates all frequencies below the set threshold.
Use the Fat Channel high-pass lter to remove unwanted low frequencies from your
source signal, rather than trying to EQ them out.
7. Mic Preamp Trim. A trim control is provided for all input channels
to adjust the gain of your digitally controlled XMAX preamps.
Note: This control is not available for StudioLive AI-series console mixers as these
mixers are not equipped with digitally recallable mic preamps.
8. Input Delay (StudioLive Series III mixers only). Sets the alignment
delay for the currently selected channel. For more information on using
an Input Delay, please review the StudioLive Series III Owners Manual.
9. Main Bus Assign. Use this button to assign the current channel
to the main bus. Additional bus controls are as follows:
• StudioLive 64S: Main Mono/Center
• StudioLive Series III mixers (32-channel models): Main Mix, Subgroups A-D
• StudioLive AI-series consoles: Main Mix, Subgroups 1-4
• StudioLive AI-series RM/RML mixers: Main Mix, Mono
Note: StudioLive RM-series and Series III mixers oer exible mix functionality that
allows you to make any FlexMix function as an aux bus or subgroup. Please see
Section 2.4.2 for channel routing to a FlexMix subgroup.
2.3.3 Channel Settings
When a channel is selected, the Settings icon for that channel is visible in the left side
Bekijk gratis de handleiding van PreSonus UC Surface, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | PreSonus |
| Model | UC Surface |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14432 MB |
