Prebena 2XR-J50 handleiding
Handleiding
Je bekijkt pagina 30 van 60
30
PREBENA-Pneumatic staplers and nailers
6. Troubleshooting
In case of complex operating difficulties, please call us.
Our service department will deal with your problem as quickly as possible.
The tacker will not eject a fastener.
Fasteners are not being driven in all
the way.
Air is leaking from the tool.
The tacker is shooting ”blanks”.
The magazine opens when the
trigger is pulled.
When the trigger is pulled,
no fastener is ejected.
s The air pressure is too low
s control elements stuck together with grease
after lengthy storage period.
s The air pressure is too low for the job at hand.
s The driver tip is possibly worn down.
s The screws holding the top plate in place are
loose. s Defective seal or o-ring.
s The fastener is not pushed far enough forward
in tacker.
s The piston and driver did not return to the
original position after firing.
s The triggering procedure was not completed
correctly. s Lack of grease. s Air pressure too
lo
s The fastener cannot penetrate the work
material.
s Use of non authorised fastener.
s Safety catch worndown.
s Spring under safety catch worn out.
s Interference with firing groove and
the tool plate.
s Driver broken.
s Driver hitting two fasteners at once.
The connector between the piston and the
driver is broken. The driver tip remains visible
at the muzzle after the driving mechanism
has returned to its starting position.
Problem Possible Cause
Bekijk gratis de handleiding van Prebena 2XR-J50, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Prebena |
| Model | 2XR-J50 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5198 MB |
