Practixx PX-TFM-40 handleiding
Handleiding
Je bekijkt pagina 36 van 120
www.scheppach.com www.scheppach.com
36
|
GB
17. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
The machine will not
switch on
Mains voltage is not
available.
Check power supply
Carbon brushes worn Contact the customer service workshop
Machine switches o
automatically while
idling
Mains failure
Check fuse on the mains side.
Due to the built-in undervoltage protection, the machine
does not restart by itself and must be switched on again
when the voltage is restored.
Machine stops during
machining
Overload protection has
tripped due to the cutter
blade being blunt, or the
feed rate or cutting depth
being too great
Before continuing work, replace the blades or wait for
the motor to cool down.
Speed drops during
machining
High degree of chip take-o Reduce chip take-o
Feed to high Reduce the feed speed
Blunt cutter Replace cutter
Untidy cutting pattern
Blunt cutter Replace cutter
Uneven feed Cut with constant pressure and reduced feed rate
Chip ejector clogged
(without extraction)
High degree of chip take-o Reduce chip take-o
Blunt cutter Replace cutter
Wood is too wet Only machine dry wood.
Bekijk gratis de handleiding van Practixx PX-TFM-40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Practixx |
| Model | PX-TFM-40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18274 MB |
