Practixx PX-CS15T handleiding
Handleiding
Je bekijkt pagina 47 van 76
w ww.practixx.com
GB
|
47
11.8 End of work (Fig. 1, 12)
1. Move the splitting column (2) to the bottom posi-
tion.
2. Release the control lever on the left (18).
3. Actuate the stop lever (21).
4. Switch off the motor (17) (see section 10.5) and
disconnect the mains plug.
5. Swivel in the swivel table (8) by foot until the lock-
ing hook (9) engages.
6. Close the bleed screw (15).
7. Protect the device from moisture!
8. Observe the general maintenance information.
12. Maintenance and repairs
m WARNING!
Danger of injury!
The device can start unexpectedly and cause injuries.
- Switch the motor off before performing any mainte-
nance work.
- Disconnect the mains plug before carrying out any
maintenance work.
m WARNING!
Health hazard!
Inhalation of oil vapours can cause serious damage to
health, unconsciousness and in extreme cases death.
- Do not inhale oil vapours.
- Operate the device outdoors only.
NOTE
Product damage
If the product is operated without or with too little hy-
draulic oil, this can lead to hydraulic pump damage.
NOTE!
Environmental damage!
Spilled oil can pollute the environment permanently.
The liquid is highly toxic and can quickly lead to water
pollution.
- Fill/empty oil only on level, paved surfaces.
- Use a lling nozzle or funnel.
- Collect drained oil in a suitable container.
- Wipe up spilled oil carefully immediately and dis-
pose of the cloth according to local regulations.
- Dispose of oil as per local regulations.
All protective and safety equipment must be reassembled
immediately after repair, maintenance is completed.
7. If the log has not been completely split during the
rst splitting stroke, proceed as described in sec-
tion 11.5.
11.5 Starting position log lifter (7) (Fig. 17, 17a)
Note
This is used as a second guard arm when not using
the trunk lifter.
1. Put the trunk lifter (7) in the resting position.
2. Secure the log lifter (7) with the log lifter lock (26).
11.6 Remove jammed log (Fig. 1)
Note:
Use the swivel table to split the jammed wood and
knock it out against the direction of splitting.
m ATTENTION!
Danger of injury!
The swivel table must engage in the locking hook!
m ATTENTION!
Danger of injury!
There is a danger of knotty logs becoming jammed dur-
ing the splitting process. Please note that the wood is
under a lot of tension when it is removed and parts of
your body can be crushed in the split crack.
- Do not reach into the log splitter when it is running.
- Do not put any objects into the log splitter while it is
running (e.g. hammer or similar).
1. If the log is not completely split during the rst split-
ting stroke, carefully move the splitting wedge (3)
with the log to the upper position using the control
lever on the right (5) and the control lever on the
left (18).
2. Swivel in the swivel table (8) by foot until the lock-
ing hook (9) engages.
3. Now carry out a second splitting stroke until the
log is completely split.
4. Remove the log and swivel the swivel table (8)
away with your foot.
11.7 Restart protection in the event of a power fail-
ure (zero voltage trigger)
In the event of a power failure, unintentional removal
of the plug or a defective fuse, the device switches off
automatically.
To switch on again, proceed as described in section
10.5.
Bekijk gratis de handleiding van Practixx PX-CS15T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Practixx |
| Model | PX-CS15T |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10629 MB |
