Powr-Flite C201HD handleiding

Handleiding

123456789/ 9

Afdrukken

Je bekijkt pagina 5 van 9

5

TO GUIDE YOUR FLOOR MACHINE

To Right: raise handle slightly. The higher the handle is lifted, the faster the machine will move to

the right. To Left: to change direction, lower the handle until the machine travels to the left. The

more the handle is lowered, the faster the movement to the left.

TRANSPORTING THE MACHINE

Place the handle in the upright position. Lock the handle cam release lever. Tip the machine

back and transport on the wheels.

MAINTENANCE

Once a month remove the motor cover and vacuum out any dust or debris which has

accumulated on the motor. Replace the motor cover by setting it over the holes in the housing

and replace all of the screws. Check and maintain the tightness of all the fasteners.

WARNING: Do not over-tighten the switch housing screws.

Keep the machine clean especially at the handle tube and collar so the handle tube will move

freely through the collar. Inspect the cord for cuts, gashes, or loose prongs; replace as needed.

Disassembly of this motor voids the warranty. Improper disassembly and assembly of this

motor can permanently damage the field or rotor.

TROUBLESHOOTING

Problem Possible Cause

Machine will not start

Circuit breaker is not reset. Reset breaker.

Plug is broken or has a loose contact. Replace.

Circuit breaker is defective or weak. Replace.

Switch is defective. Replace switch.

Machine will not reach operating speed

Over drawn circuit. Unplug anything other than the

machine from the circuit or locate another circuit.

Motor runs but pad or brush does not

turn

Coupling is broken. Replace. Coupling is not

covered under warranty. Do not attempt to place

a running machine over a block or brush. Always

install and remove the block or brush by hand.

Prevent circuit overload.

Check the pad and change it if it is rough or dirty. Spray buffing or spray cleaning is not a

substitute for scrubbing or mopping a floor. Prepare the floor surface before spray buffing.

Eliminate any extension cord that is smaller than 12/3 wire or greater than 25 feet in length.

Unplug anything other than the machine from the circuit or locate another circuit.

123456789/ 9

Bekijk gratis de handleiding van Powr-Flite C201HD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Boenmachine