PowerWalker VI 1500 RT HID handleiding
Handleiding
Je bekijkt pagina 26 van 37
25
EN
Warning:
This circuit must be separated from hazardous voltage circuits by
reinforced insulation.
Caution:
The EPO must not be connected to any utility connected circuits.
Reinforced insulation to the utility is required. The EPO Switch must have
a minimum rating of 24Vdc and 20mA and be a dedicated latching-type
switch not tied into any other circuit. The EPO signal must remain active
for at least 20ms for proper operation
EPO Connections
Wire Function Terminal Wire Size Rating Suggested Wire Size
EPO 4-0.32mm
2
(12-22AWG) 0.82mm
2
(18AWG)
Note: Leave the green EPO connector installed in the EPO port of the UPS
even if the EPO function is not need. Remove the small cable from EPO
connector.
EPO Connector
5.3 Network Management Card (Optional)
Network Management Card allows the UPS to communicate in a variety of
networking environments and with different types of devices. The series UPS has
one available communication slot for Webpower or other optional card to achieve
remote management of the UPS through internet/ intranet. Please contact your
local dealer for further information.
Bekijk gratis de handleiding van PowerWalker VI 1500 RT HID, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | PowerWalker |
| Model | VI 1500 RT HID |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2727 MB |
