PowerWalker Solar Inverter 6k SAN 3/3 handleiding

Niet gecategoriseerd

PowerWalker

69 pagina's

PDF beschikbaar

Handleiding

PowerWalker User Manual

3.3 Mounting

NOTE

• Depending on the mounting bracket included in the packaging, please follow the correct

instructions for Type I or Type II.

• Before mounting the inverter, you have to prepare expansion screws and security screw.

3.3.1 Mounting bracket Type I

Step 1. Install the mounting bracket

1) Use a level ruler to mark the position of the 3 holes

on the wall. Refer to Figure a. And drill 3 holes,

13mm in diameter and 40mm in deep. Refer to

Figure b.

2) Knock the expansion screw kit into the hole

together with a hammer. Refer to Figure c.

3) Note: Do not remove the nut unit in this step.

4) After tightening 2-3 buckles, the expansion bolts

are tight and not loose, and then unscrew the bolts,

spring washer, gasket. Refer to Figure c.

5) Install and fix the mounting bracket on the wall.

Refer to Figure d.

493.4

14.0

320.0

160.0

14.0

92.0

10.0

Unit: mm

Step 2. Install the inverter on the mounting bracket. Then lock the inverter using the security

screw. Refer to Figure e and f.

DANGER

Before drilling the hole on the wall, ensure no damage on the electric wire and/or water pipe

inside the wall.

CAUTION

To prevent potential damages and injuries from inverter falling down, please hang the

inverter on the bracket, do not loosen grip unless confirm the inverter is well mounted.

3 × M10 Expansion screw

Ø: 13 mm; Depth: 40 mm

Drill the holes.

Mark the holes position

on the wall.

Set bracket horizontally.

(M10; 3 suites)

Expansion screw group

A & B

E D C B A

M6 Security screw; 2.5N·m

M10

26N·m

C & D & E

Bekijk gratis de handleiding van PowerWalker Solar Inverter 6k SAN 3/3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.