PowerWalker MDC 3K42U handleiding
Handleiding
Je bekijkt pagina 9 van 138
1
Safety precautions
1 Safety precautions
General requirements
• Read this manual carefully before operating the product.
• The “caution” and “warning” sections in this manual do not represent all the safety precautions.
These sections only highlight some points for safety precautions.
• This product is recommended for commercial or other professional use.
• This product is to be used for its design purposes only and we will not accept any responsibility
of misuse.
• The areas inside the product cabinet are restricted areas. We recommends that access to
restricted areas be given to authorized employees only.
• The product password must be kept by the designated person-in-charge.
• For the safety precautions of the uninterruptible power systems (UPS) and air-conditioners,
refer to their user manuals and maintenance manuals.
Electrical safety
•
For electrical connections, insulating tools must be used.
•
After the product emits a warning through the monitoring floor, locate and eliminate the cause
promptly to avoid further problems or failures.
Risk of electric shock
An electric shock can cause personal injury or even death. Therefore, pay attention to the
following points:
•
Before working on components inside the product, disconnect the control box and the remote
power supply.
•
Before installation, read all the operating instructions, verify that all the components are received
at the installation site and check the nameplate to ensure that the voltage matches the mains
supply.
•
Comply with the on-site or local laws and regulations.
Cooling unit safety
•
Use the R410A refrigerant only.
•
Brass must support a minimum working pressure of 55bar.
•
At least two persons are required on a welding site. A welder must have a work permit.
•
In the welding site, inflammables must be avoided, and a fire extinguisher, wet wiper, and water
container must be available.
•
A burning welding torch must not be placed on a component or on the floor and must not be
placed in a metal container with acetylene and oxygen. Otherwise, the gas may leak and cause a
fire.
•
High-temperature pipes after welding must be promptly cooled.
•
Do not weld or cut on pressurized containers or pipes. Electric devices must be powered off
before welding.
Bekijk gratis de handleiding van PowerWalker MDC 3K42U, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | PowerWalker |
| Model | MDC 3K42U |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 22093 MB |
