PowerWalker LiFe Battery System 102-37 handleiding

Niet gecategoriseerd

PowerWalker

50 pagina's

PDF beschikbaar

Handleiding

~ 41 ~

4 Powering the System

4.1 Preparation before running:

1) Confirm the battery system is securely installed.

2) The location should have good ventilation.

3) No external objects or parts are placed on top of the battery system.

4) Cables are properly distributed, tight, and well-protected from mechanical damage.

5) Ensure that all terminals are properly and securely connected, and that the battery cabinet is properly

grounded.

4.2 Run the battery system (test drive):

Step 1: Switch the DC breaker of all paralleled battery packs to the “ON” position, press the power

button in the control box for 3 seconds to wake up all the paralleled battery packs from shutdown

status (To connect the system 12V supply can also wake up battery pack).

Step 2: Check the LED condition of the power button in the control boxes. If the LEDs of the power

button in the control boxes are all steady green, the paralleled battery packs are in normal

working condition. If the LEDs of the power button are blinking or steady red, it means there is

a fault in the battery packs, check the fault information through communication.

Step 3: Starting up the inverter, set the inverter according to its manual to charge and discharge the

parallel battery pack for one cycle. Check whether the battery pack can operate normally with

the inverter. If after a complete charge and discharge cycle the battery side has no protection and

fault information is transmitted to the inverter, and no fault is triggered at the inverter side, it

means the battery packs can be matched to the inverter.

Bekijk gratis de handleiding van PowerWalker LiFe Battery System 102-37, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.