Posiflex PP-8800 handleiding
Handleiding
Je bekijkt pagina 15 van 21
Part 15
In case any foreign materials like a staple or paper clip or excessive paper scraps
fall into the auto cutter mechanism the auto cutter may lock up and so does the
print hood. In such case, please pull the cutter cover forward to expose the cutter
adjustment area. Apply some mechanical assistance in below procedures to help
resetting the cutter blade back to its home position. Please lift up a transparent
protective cover over the adjustment wheel with the printer powered off. Turn this
white color wheel downward for 4 ~ 5 strokes. Close the cutter cover back and turn
the printer power on to see if the auto cutter lock up problem is resolved.
If the problem is not automatically resolved by above procedures, please
power off the printer and open the cutter cover again. Check in the alignment
window while turning the gear downward as above or with a small Phillips
screwdriver at the right side of the cutter mechanism. When the cutter blade returns
to its standard position, a hole in the white plastic gear will show up in the window
as illustrated in detailed picture above. Close the cutter cover when finish. The lock
up of the print hood can then be released after this problem solved.
Please use manual cutter as temporary alternative measure once the auto
cutter malfunctioned.
Advanced Analysis Tool
This printer supports Hexadecimal Dump for experienced user to view
exactly what data is received by the printer. This can be useful in finding software
problems.
To start the dump mode: Turn off printer; Open print hood; Hold down
FEED button while turning printer on; Close the hood.
To stop the dump mode: Press the FEED button to print out the last line;
Turn off the printer.
During dump mode: All commands except DLE EOT and DLE ENQ are
disabled.
USEFUL TIPS
Please note that only those qualified technicians may adjust several jumpers for
some technical settings. Please visit our web site http://www.posiflex.com or
http://www.posiflex.com.tw for details of the technical information such as
driver installation, DIP switch settings and command sets etc. if required.
Place the printer on a sturdy, level surface.
Choose a place that is well ventilated and free of excessive dust, smoke or
fume.
Do not put the printer under direct sunlight or near a heater.
Ideal room temperature is from 5ºC to 40ºC. Ideal humidity is from 20% to
85% RH (no condensation).
Do not set any liquid or drinks such as coffee on the printer case.
Do not touch any metal part to avoid possible electrostatic damage.
Do not touch the areas around the print head and motor during or right after
printing. It can be very hot.
Bekijk gratis de handleiding van Posiflex PP-8800, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Posiflex |
| Model | PP-8800 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3150 MB |
