Handleiding
Je bekijkt pagina 7 van 52
GB
USE OF OIL FILLED RADIATOR
Butterfly nuts
Wheel
Blue tape
Feet
Control box
figure 1 figure 3 2 figure
OPERATING
[Inspection before start]
7
• Remove the feet from the intermediate heat sink and remove the
wheels from the foam. Press the wheels on the supporting holes, as
shown in Figure 1.
• Refer to figures 2 and 3. First, flip the heater so that the bottom is
facing upwards. Align the two circular holes of the support assembly
to the two screws at the bottom of the control box and press the
assembly down. Next, remove the blue tape on the support foot and
take out the butterfly nuts. Secure the foot assembly with the
butterfly nuts. Make sure the mounting groove of the foot assembly is
aligned and clamped with the clamping groove on the second heat sink.
• After the feet are firmly installed, put the heater right side up and the
wheels will now touch the ground.
1. The mains cable should not be damaged or fractured.
2. This radiator uses 220-240V AC power. Verify that the rated
current of the power socket is in line with these requirements and
is equipped with a safety grounding device before use; otherwise,
replace the socket.
Bekijk gratis de handleiding van Point POOH1500WH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Point |
| Model | POOH1500WH |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 3309 MB |
