Handleiding
Je bekijkt pagina 8 van 47
BULB REPLACEMENT
The bulb must be replaced by the manufacturer, its
service agent or similarly qualified persons.
Always switch o
the electricity supply before carrying
out any operations on the appliance. When handling
bulb, make sure it has completely cooled down before
any direct contact with hands.
When handling blubs, hold with a cloth or gloves to
ensure perspiration does not come in contact with the
blub as this can reduce the life of the blub.
Important :
Note:
• Before changing the lights, make sure that the appliance is turned o and
unplugged.
• Protect against danger when changing lights, such as wearing gloves.
Changing the lights:
• Remove the grease filter.
•
• Apply the reverse procedure to reinstall the light.
ILCOS D code for this lamp is: DSR-1.5/65-S-64
– LED modules –round lamp
– Max wattage: 2×1.5W
– Voltage range: DC 12V
– Dimensions: φ64mm
14
15
GB
NOTE:
•
Make sure the filter is securely locked. Otherwise, it would loosen and cause
danger.
• When activated carbon filter attached, the suction power will be lowered.
INSTALLING GREASE MESH FILTERS
To install filters, following four steps .
- Angle the filter into the slots at the back of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon
filter should be changed every 3 to 6 months according to your cooking habits.
The installation procedure of activated carbon filter is as below:
1. Before installing or replacing the carbon filters, disconnect the mains power
to the unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both sides of the motor anti-clockwise. Replace the
carbon filters with the new carbon filters.
4. Place the mesh filter.
5. Connect the power supply to the wall socket.
Use a tool or the hand to press the spring splinter of both sides of LED light to
the inside, until the light is pressed out. Then slightly pull the light connecting
wire out, and dismantle the terminal of the light connecting wire.
Bekijk gratis de handleiding van Point POHO5052INTB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Point |
| Model | POHO5052INTB |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 6004 MB |
