Point POAP2010V2 handleiding
Handleiding
Je bekijkt pagina 5 van 22
98
GB
“PET MODE” BUTTON
Press the button. The indicator light switches on and the air volume indicator
switches o (other indicators are not aected). The device enters deodorization
operation mode: Turbo air volume operation for 15 minutes, followed by III wind
volume operation for 5 minutes. After the deodorization operation ends, the Pet
Mode indicator light will turn o, and the air volume indicator light will turn on.
“NIGHT LIGHT” BUTTON/ “SLEEP MODE” BUTTON
NIGHT LIGHT MODE: The default setting of the button is o. One press will
switch the night light on with high setting. The second press will switch the
night light on with low settings. The third press will switch o the night light.
SLEEP MODE: Long press the button to turn on Sleep Mode. The indicator will
flash for about three seconds. All indicators, including the night light, will turn
o, and the wind speed will be set to I. To exit SLEEP MODE, press any button
(including the power button). The unit will then return to the previous setting
before Sleep Mode was activated.
“UV-C LAMP” BUTTON
Touch the button to turn on the function, and then press it again to turn o it.
“CHILD LOCK MODE” BUTTON
Long press the button for 3 seconds to turn on the mode, the CHILD LOCK MODE
indicator is on, and other functions cannot be operated. Press again for 3 seconds
to turn o the child lock function.
NOTE: When the Child Lock Function is turned on, all other functions can not be
operated except the CHILD LOCK FUNCTION. Long press the child lock button
for about 3 seconds to switch the function on and o.
Important note: When the unit is not in use, switch it o and unplug it.
INSTALLING & REMOVING FILTERS
1. Unplug the unit, turn it upside down and place it on a flat surface
(preferably on a towel, blanket or soft cloth).
2. Unscrew the base removal screw and gently lift the base from the
unit.
3. Lift the old filter out and place the new replacement filter in the
same way.
Note: It doesn't matter which side the filter is facing.
4. Fit the base on the unit and screw it back on (do not over tighten).
CLEANING & MAINTAINING
THE COMBINATION FILTER
The air purifier 3-in-1 filter should be replaced about every 6 months. When it needs to
be replaced, the RESET BUTTON will remind you, and you just need to operate it
according to the directions.
NOTE:
- The Combination Filter is one filter system. The multiple layers include: the Pre-filter,
Activated Carbon Filter and HEPA Filter.
- It cannot be washed, just replaced.
UV LAMP REPLACEMENT
1. with Open the UV lamp cover a screw driver.
2. Take o the UV lamp from the holder carefully and unplug the connector.
3. Connect the new UV lamp to the connector and fix back the lamp to the holder
carefully.
Note: look at Do not the operating UV lamp directly.
FILTERS
HEPA
Carbon filter
Pre-filter
Combination filter（Pre-filter+Carbon+HEPA）
1.
2.
Bekijk gratis de handleiding van Point POAP2010V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Point |
| Model | POAP2010V2 |
| Categorie | Luchtreiniger |
| Taal | Nederlands |
| Grootte | 2688 MB |
