Planet ICA-4880 handleiding
Handleiding
Je bekijkt pagina 36 van 89
User’s Manual of ICA-x80 series
36
8.3 Network
In the main interface, click "Config Network" to enter the network settings interface, the network
is divided into Basic Config, P2P and Email configuration.
8.3.1 Basic Setup
① TCP/IP
The TCP/IP interface is used to view and configure network parameters such as the camera's IP
address. You can enable DHCP or manually modify to configure the IPC network parameters.
Enable DHCP:
Connect IPC to the router with DHCP enabled, and then IPC will obtain the corresponding IP
address, subnet mask, default gateway, and preferred DNS server information.
The specific steps for manually modifying network parameters are as follows:
Step 1: In the main interface, click "Config Network Basic Setup TCP/IP" to enter the
TCP/IP interface, as shown in Figure 8-6 ①.
Figure 8-6 ①
Step 2: Set the IP address (IPv4 or IPv6 format), subnet mask, gateway, and DNS.
Step 3: Click "Test" to make sure the modified IP address is available in the LAN.
Step 4: Click "Apply" to save the configuration.
Bekijk gratis de handleiding van Planet ICA-4880, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Planet |
| Model | ICA-4880 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 19130 MB |