Phonic WL-1S handleiding
Handleiding
Je bekijkt pagina 5 van 20
1
WM-1S / WL-1S / WH-1S
English
Introduction
Congratulations on your purchase of Phonic’s wireless microphone system. The WM-1S, WL-1S,
and WH-1S are designed exclusively for Phonic’s Safari all-in-one mobile solutions. Phonic’s
new wireless system has state-of-the-art technology including One-Touch Frequency Autoscan
and hardware/software noise elimination. With these and many other advanced features, it is
easier than ever to setup your wireless system for excellent sound. Please read through this brief
manual for installation and operating instructions.
Components
WM-1S wireless handheld microphone system:
• WR-1 Wireless Receiver
• WM-1 Wireless Handheld Microphone
• User’s Manual
WL-1S wireless Lavalier microphone system:
• WR-1 Wireless Receiver
• WL-1 Wireless Lavalier Microphone
• WB-1 Beltpack
• User’s Manual
WH-1S wireless headset microphone system:
• WR-1 Wireless Receiver
• WH-1 Wireless Headset Microphone
• WB-1 Beltpack
• User’s Manual
Installing the WR-1 Safari Wireless Receiver Module
We recommend that an authorized Phonic repair facility or dealer/distributor carries out the steps below:
1. Remove all power cables and turn the Safari 3000 off.
2. Unscrew the protective faceplate on the wireless receiver slot and remove it.
3. Place the WR-1 into an available wireless slot and push the WR-1 into the slot until the WR-1
faceplate is ush with the back panel.
4. Screw the WR-1 into place.
Operating Safari’s Wireless System
Power Switch/Volume Knob
Volume Gain
Channel LED
Communication Status
Infrared
Auto Scan Button
Frequency Band Lock Button
One-Touch Auto Scan
1. Power-on the Safari wireless receiver (WR-
1) by turning the volume knob clockwise.
You should hear a click sound from the
knob.
2. Power-on your handheld microphone (WM-
1) or beltpack unit (WB-1)
3. Hold the WM-1 / WB-1 close to the WR-1
receiver and push the Scan button on the
WR-1 for 4 to 5 seconds until the numeric
channel LED digits start to automatically
change. This indicates that the autoscan is
nding the best wireless channel.
4. The autoscan process is nished when the
LED display stops at the optimal channel.
At this point, the RF LEDs will activate. If
the RF LEDs on the WR-1 do not light on,
the connection has not been established
successfully. To reinforce the connection,
click the Lock button while holding the
WM-1 or WB-1 close to the receiver.
5. Upon a successful connection, the AF
LEDs on the WR-1 will activate as you
speak into the microphone.
Bekijk gratis de handleiding van Phonic WL-1S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Phonic |
| Model | WL-1S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2319 MB |
