Phonic DMP8800D handleiding
Handleiding
Je bekijkt pagina 6 van 44
4
DMP8800
English
7. Level Meters
These meters allow users to view the output signal
levels� There are four LEDs in total, the top of which
indicates whether the output signal is clipping�
8. Meter Button & Input LED
Pushing this button will change the status of the level
meter between that of a pre-DSP input signal level meter
and an output level meter�
9. Phantom Power LEDs
These LED indicators will light up when the corresponding
input’s phantom power circuit is activated� Phantom
power itself can be turned on using the Asystems
software�
10. Remote Enable LEDs
When a remote level control is connected and active
for the corresponding channel, this LED will indicate as
such�
11. Enable LEDs
This LED will light up when the corresponding channel is
activated� This is done through the DMP8800 software�
12. Gain Controls
These rotary controls will allow users to adjust the nal
input level for channels 1 through 8�
REAR PANEL
13. Ethernet Connection
This connection is for standard RJ-45 cables, used
for 10/100 Ethernet control� Using a CAT5 twisted pair
copper cable, Asystems doesn’t recommend a distance
of more than 100 meters to the nearest computer or
hub� The Ethernet connection is used to control the
software via the PC control software and the RM-6E
programmable remote controls�
14. Euroblock Line Inputs
The DMP8800 offers a total of eight line input channels�
These inputs are active balanced with euroblock
connectors� If an unbalanced signal is used, Asystems
advises that customers ground the unused conductor�
15 RCA Line Inputs
These unbalanced RCA connectors are for the
connection of stereo RCA cables� They accompany each
of the eight line input channels mentioned previously�
The stereo signals these inputs receive are summed to
create a mono mix�
16. Line Outputs
The DMP8800 offers a total of eight line outputs� These
are servo-balanced euroblock connectors and can be
wired to either balanced or unbalanced connections�
17. Peripheral Connector
This RJ-45 connector is for connecting Asystems remote
peripherals to the DMP8800 series processor�
18. USB Connectors
Two USB connectors have been included on the
DMP8800 for use with a USB mouse – either wired or
wireless – and USB ash drives. A USB mouse can be
used to control the internal software without the need
of a computer. The ash drive can be connected when
performing rmware updates.
19. VGA Connector
This is a standard XVGA connector for use with standard
computer monitors and high denition displays. This will
allow you to control the internal software of the DMP8800
without the need of a computer�
9
10
11
12
8
7
13
15 14
16
17
21
181920
22
Bekijk gratis de handleiding van Phonic DMP8800D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Phonic |
| Model | DMP8800D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9601 MB |
