Phonic DMP808D handleiding
Handleiding
Je bekijkt pagina 16 van 56
14
English
DMP808 / DMP808D
Signal Generator
The Channel Inputs and Matrix Output can have a signal
generator applied to them. The option can be found in the
Channel Matrix and Mix Matrix pages by right clicking the
mouse. The signal generator can be activated with the
“ON” buttons and assigned to the appropriate mixes using
the matrix/channel select section below the controls.
There are 4 dierent signals available, including White
Noise and Pink Noise – ideal for setup of systems – and
sine and sweep waves – for testing of equipment and for
general setup purposes.
Sine: The sine wave can be selected between 20 Hz and
20 kHz. The signal level can also be adjusted, and the
signal can be turned on and o.
Sweep: When using the sweep wave, a lowest and
highest frequency can be selected. The sweep wave will
move between these frequencies and small increments.
The hold time for each frequency can be selected by the
users. There are also controls for adjusting the signal level and turning the sweep wave on and o.
Pink Noise: The pink noise function includes level controls and on/o button.
White Noise: Like the pink noise, the white noise only oers level controls and an on/o button.
Network Matrix
Any of the incoming input signals can be assigned directly
to the Network output mixes. The network matrix pages
are only used when the Asystems network expansion card
is installed in the DMP808. Attenuation: Adjust the input
level of each of the individual input and output mixes.
Panning: These will let you adjust the left/right mix of the
available mixes.
ALC: This button will assign the DMP808’s Auto Level
Control to the corresponding input.
Duck: Pushing this button will apply the ducking feature to
the corresponding mix. The duck function can be activated
as ducker 1, ducker 2, or o, the settings of which are
decided by their respective menus.
INV: This button will invert the phase of the corresponding
input or matrix signal.
On: This button allows you to turn the corresponding input
signal on and o. When turned o, the signal will not be
sent to any of the matrix outputs selected.
Routing: Each of the 12 analog inputs, 8 matrix inputs and 8 matrix outputs can be assigned to the DMP808’s 8 network
outputs. These channels will appear as Network Input connections in any networked Asystems DMP, DMA or NT series
devices.
Bekijk gratis de handleiding van Phonic DMP808D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Phonic |
| Model | DMP808D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11121 MB |
