Phoenix Contact TC MOBILE I/O X200-4G AC handleiding

Niet gecategoriseerd

Phoenix Contact

82 pagina's

PDF beschikbaar

Handleiding

Installation

107812_en_08 Phoenix Contact 15 / 82

3.3 Mounting

WARNING: Danger to life from electric shock

Only mount or remove the device when it is disconnected from power.

WARNING: Danger to life from electric shock

AC device TC MOBILE I/O X200-4G AC: The devices have basic insulation only.

• Mount the devices at least 5 mm away from other modules.

3.3.1 DIN rail

• Use a grounding terminal block to connect a 35 mm EN DIN rail to protective ground.

The device is grounded by snapping it onto the DIN rail.

• Place the device onto the DIN rail from above.

• Push the front of the device toward the mounting surface until it snaps into place au-

dibly.

Figure 3-1 DIN rail mounting

3.3.2 Wall

There are two removable base latches for wall mounting on the back of the device.

• Push the snap-in latch downwards with a screwdriver and pull out the base latch.

• Insert a washer between the extended base latch and the even surface.

• Secure the device to the wall using the screws.

– Maximum thread diameter 4 mm

– Maximum head diameter 8.5 mm

Figure 3-2 Wall mounting

A B

Bekijk gratis de handleiding van Phoenix Contact TC MOBILE I/O X200-4G AC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.