Phoenix Contact IB IL AO 4/U/0-10-ECO Handleiding (190 Pagina's)

Handleiding

Je bekijkt pagina 117 van 190

Mounting/removing devices

6452_en_11 Phoenix Contact 117 / 188

11.5 Mounting/removal

11.5.1 Inline: Mounting/removal

Mounting side by side

(Inline)

An Inline station is set up by mounting the individual components side by side. No tools

are required. Mounting the components side by side automatically establishes the poten-

tial and bus signal connections between the individual station components.

After a station has been set up, individual terminals can be exchanged by pulling them out

or plugging them in. Tools are not required.

End clamps

(Inline)

Mount end clamps on both sides of the Inline station. The end clamps ensure that the In-

line station is correctly mounted. End clamps secure the Inline station on both sides and

keep it from moving from side to side on the DIN rail. For the recommended end clamps,

please refer to Section “Ordering data” on page 162.

When mounting on a horizontal DIN rail, the end clamps can be snapped onto the DIN rail

at any point during station assembly.

When mounting on a vertical DIN rail, secure the end clamp on the left at the start of sta-

tion assembly, so as to prevent the station from slipping down.

End plate

(Inline)

The end plate terminates an Inline station. It has no electrical function. It protects the

station against ESD pulses and the user against dangerous contact voltages. The end

plate is supplied with the bus coupler and does not have to be ordered separately.

Order of the Inline termi-

nals

When mounting, observe the correct order of the Inline terminals (see Section “Order of

the Inline terminals” on page 125).

Bekijk gratis de handleiding van Phoenix Contact IB IL AO 4/U/0-10-ECO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.