Phoenix Contact IB IL AO 4/U/0-10-ECO Handleiding (190 Pagina's)

Handleiding

Je bekijkt pagina 107 van 190

Mounting/removing devices

6452_en_11 Phoenix Contact 107 / 188

11.2 Mounting distances

The space required for cable routing depends on the number of cables to be installed and

must be left free on the left and/or right-hand side.

In order to minimize the parallel installation of signal and power supply lines, the cable

duct on the left can be used for the signal and bus lines, for example, and the duct on the

right for the power supply lines. This ensures that the parallel installation of these cable

types is kept to a minimum and limits interference on the signal lines.

For the distances of the upper and lower cable ducts or the cable routing to the devices,

please refer to the sections below.

11.2.1 Mounting distances for Inline terminals

11.2.1.1 Mounting distances for terminals in the 24 V DC, 120 V AC, and 230 V AC

areas (excluding terminals with fiber optic connections)

Figure 11-4 Mounting distances for terminals in the 24 V DC, 120 V AC, and 230 V AC

area (in mm)s

If the distances are smaller, the minimum bending radius of the cables, easy han-

dling during installation, and a clear structure cannot be guaranteed.

30

40

190

75

6060

Bekijk gratis de handleiding van Phoenix Contact IB IL AO 4/U/0-10-ECO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.