Phoenix Contact CSS 1.5-1/3-EMC Handleiding (152 Pagina's)

Handleiding

Error codes

109908_en_02 Phoenix Contact 95 / 150

12 Error codes

If an error is shown on the device, the “PWR/STO/ERR” LED flashes red.

If an internal error is shown on the device, the “PWR/STO/ERR” LED is permanently on.

In the event of a reset, press <SET/RESET> or activate the RESET input for 0.5 s ... 3 s to

acknowledge the error.

The error codes and the corrective actions are listed below.

ID Display on the control panel Error name Error descriptions

1 PHL - phase loss protection Phase loss protection (PHL) Phase loss of power input

Reset

Reset method Manual reset

Reset condition Reset after the fault is cleared.

Cause Remedial measures

Mains phase failure Check the wiring of the mains connection.

Check the fuses.

ID Display on the control panel Error name Error descriptions

2 UV - Under voltage error Undervoltage (UV) DC link voltage is lower than safe operating voltage

Reset

Reset method Manual reset

Reset condition Reset is possible once the DC link voltage is higher than the following

values:

230 V AC models:

150 V AC ... 240 V AC input: >210 V DC

110 V AC ... 149 V AC input: >105 V DC

480 V AC models:

300 V AC ... 480 V AC: >420 V DC

220 V AC ... 299 V AC: >210 V DC

Cause Remedial measures

Power failure Improve the power supply conditions.

Power voltage changes Adjust the voltage of the CONTACTRON Speed Starter’s power range

setting.

Motor start with large load Check the load.

Increase the power of the power supply devices.

Load is too large. Reduce the load.

Increase the CONTACTRON Speed Starter power.

Increase the acceleration time.

Bekijk gratis de handleiding van Phoenix Contact CSS 1.5-1/3-EMC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.