Philips BG3470 handleiding
Handleiding
Je bekijkt pagina 2 van 2
BG3470/15
BG3480/15
ENGLISH
Important safety information
Read this important information carefully before you
use the appliance and its accessories and save it for
future reference. The accessories supplied may vary for
dierent products.
Warning
- To charge the product, only use a certied safety
extra low voltage (SELV) supply unit with output
rating 5 V, ≥ 1 A. For safe charging in a moist
environment (e.g. in a bathroom), only use an IPX4
(splash-proof) supply unit. A suitable supply unit
(e.g. Philips HQ87) is available via www.philips.com/
support. If you need support nding the correct USB
supply unit, contact the Consumer Care Center in
your country (see the international warranty leaet
for contact details). Using a non-certied supply unit
may cause hazards or serious injuries.
- Keep the USB cable and the USB supply unit dry (Fig.
2).
- This appliance is waterproof (Fig. 3). It is suitable for
use in the bath or shower and for cleaning under the
tap. For safety reasons, the appliance can therefore
only be used without cord.
- This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children
without supervision.
- Do not modify the supply unit.
- Do not use the supply unit in or near wall sockets
that contain an electric air freshener to prevent
irreparable damage to the supply unit.
- Do not use a damaged appliance. Replace damaged
parts with new Philips parts.
- Because of hygiene, only one person should use the
appliance.
- Unplug the appliance before cleaning it with water.
- Only use cold or lukewarm water to clean the
appliance.
- Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids to clean the
appliance.
- Only use original Philips accessories or consumables.
- Charge, use and store the product at a temperature
between 10°C and 35°C.
- Keep product and batteries away from re and
do not expose them to direct sunlight or high
temperatures.
- If the product becomes abnormally hot or smelly,
changes color or if charging takes longer than usual,
stop using and charging the product and contact
Philips.
- Do not place products and their batteries in
microwave ovens or on induction cookers.
- Do not open, modify, pierce, damage or dismantle
the product or battery to prevent batteries
from heating up or releasing toxic or hazardous
substances. Do not short-circuit, overcharge or
reverse charge batteries.
- If batteries are damaged or leaking, avoid contact
with the skin or eyes. If this occurs, immediately rinse
well with water and seek medical care.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic elds.
Introduction
Congratulations on your purchase and welcome to
Philips.
To fully benet from the support that Philips oers,
register your product at www.philips.com/welcome.
You can nd the model number on the back of your
product.
The full model number (e.g. BG1234/56) is located on
the bottom of the packaging, your receipt or order
conrmation.
IMPORTANT TO KNOW
- Charge the appliance fully before you use it for the
rst time.
- This appliance is waterproof (Fig. 3). It is suitable for
use in the bath or shower and for cleaning under
the tap.
- For safety reasons, the appliance can only be used
without cord.
- You can use the appliance wet or dry to shave or
trim hair on all parts of the body below the neckline.
The appliance is not intended for shaving or
trimming your face or head.
- While the appliance can be used both wet and dry,
we recommend using it on clean, dry hair, as wet
hair tends to stick to the body.
- Always check the shaving head, the trimming head
and the cutting units before use to make sure they
are clean, in good condition and not damaged or
worn. A damaged part can cause skin irritation and
reduced product performance.
- Whenever possible, stretch the skin with your free
hand for easier shaving or trimming.
- Clean the appliance after each use (see 'Cleaning').
General description (Fig. 1)
1 Cutting unit of shaving head
2 Shaving head
3 Release button
4 On/o button
5 Battery status indicator
6 Socket for small plug
7 Small plug
8 USB cable
Note: The USB supply unit is not provided. A suitable
USB supply unit (e.g. Philips HQ87) is available via
www.philips.com/support.
9 Shaving comb 2 mm
10 Shaving comb 3 mm (only with model BG3480)
Not shown: cleaning brush
Charging
- Charging or using the appliance at temperatures
below 10 °C or higher than 35 °C adversely aects
the lifespan of the battery.
- If the appliance is subjected to a major change in
temperature, pressure or humidity, let the appliance
acclimatize for 30 minutes before use.
Battery status indicator
Battery status Indicator mode
Almost empty Flashing orange light
Charging Flashing white light
Fully charged Solid white light
Note: Approx. 60 seconds after the battery is fully
charged, the battery status indicator switches o
automatically.
Charge the appliance before rst use and when the
battery status indicator shows that the battery is almost
empty. When the appliance has charged for 60 minutes,
it has an operating time of up to 100 minutes.
Warning: Keep the USB cable and the USB supply
unit dry (Fig. 2).
1 Make sure the appliance is switched o.
2 Insert the small plug of the USB cable into the socket
in the bottom of the appliance (Fig. 4).
3 Insert the USB plug into the USB supply unit (not
provided) (Fig. 5).
4 Insert the USB supply unit into the wall socket (Fig.
6).
5 After charging, remove the USB supply unit from
the wall socket and pull the small plug out of the
appliance.
Using the appliance
Always check the appliance and all accessories
before use. Do not use the appliance or any
accessory if it is damaged, as this may cause injury.
Always replace a damaged part with one of the
original type.
Because of hygiene, only one person should use the
appliance.
Detaching and attaching the shaving head
1 To detach the shaving head from the appliance,
press the release button at the back of the handle
and gently lift the head o the handle (Fig. 7).
2 To attach the shaving head onto the appliance, align
the head with the top of the handle and gently press
it down until it clicks into place (Fig. 8).
Switching the appliance on and o
To switch the appliance on or o, press the on/o
button once.
Shaving
- When shaving sensitive areas for the rst time,
you may experience some discomfort, irritation or
reddening of the skin. This is normal as your skin
needs time to adjust to shaving.
- For fast shaving, hold the appliance in such a way
that both the front teeth and the cutting unit of
shaving head touch the skin. This allows you to catch
both short and long hairs in each stroke (Fig. 9).
- If your hair is longer than 10 mm, pre-trim your hair
to a shorter length rst for optimum shaving results.
1
2
1
2
BG3480
Model
BGxxxx
2 mm
3 mm
4
5
6
7
8
10
9
3
2
1
2
1
5
8
6
9
7
10
11
14
17
20 21 22
23
12
15
18
13
16
19
3
4
4
Shaving body hair
Use the shaving head to shave body hair below the
neckline.
1 Attach the shaving head onto the appliance (see
'Detaching and attaching the shaving head').
2 Switch on the appliance.
3 Stretch your skin with your free hand. Place the
shaving head in such a way so that both the front
teeth and the cutting unit of shaving head touch
the skin. Gently press the shaving head onto the
skin and move it slowly and smoothly against the
direction of hair growth (Fig. 10).
Do not press too hard. Too much pressure can distort
the cutting unit of shaving head and cause skin
irritation.
The shaving head is bi-directional, which means that
you can shave by moving the appliance up and down.
Shave against the direction of hair growth for optimal
performance.
4 Switch o and clean the appliance after each use
(see 'Cleaning').
Shaving combs
You can attach a shaving comb onto the shaving head
to trim hairs to an even length. The numbers on the
combs correspond to the remaining hair length in
millimeters.
Attaching and detaching shaving combs
1 To attach a shaving comb onto the shaving head,
align the indent in the comb with the notch on the
back of the shaving head. Then simply snap the
comb onto the shaving head ('click') (Fig. 11).
2 To detach the shaving comb from the shaving
head, place a ngernail between the comb and the
shaving head to the left or right of the notch on the
back. Then pull the back of the comb upwards (Fig.
12).
Do not pull at the sides or teeth of the shaving comb
to remove it.
Trimming with a shaving comb
1 Attach the shaving comb onto the shaving head (see
'Attaching and detaching shaving combs').
2 Switch on the appliance.
3 Move the appliance slowly and with light pressure
against the direction of hair growth (Fig. 13).
4 Switch o and clean the appliance after each use
(see 'Cleaning').
The comb is bi-directional, which means that you
can move the appliance up and down while shaving.
Shave against the direction of hair growth for optimal
performance.
Detaching and attaching the cutting unit of
shaving head
Detach the cutting unit of shaving head for thorough
cleaning or to replace a worn cutting unit (see
'Replacement').
The cutting unit of shaving head is a precision part.
Handle it with care.
Hold the cutting unit of shaving head by its plastic
housing only (Fig. 14).
1 To detach the cutting unit from the shaving head,
hold the plastic housing of the cutting unit on both
sides and gently pull it out of the shaving head (Fig.
14).
2 To attach the cutting unit onto the shaving head,
align the cutting unit with the shaving head and
snap it into place (Fig. 15).
Cleaning
Switch o the appliance before removing or
attaching attachments.
Only use cold or lukewarm water to clean the
appliance.
Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean
the appliance.
Never dry the cutting units with a towel or tissue, as
they may get caught in the teeth and cause damage.
Cleaning the shaving head
Do not clean the cutting unit of shaving head with the
brush. The brush can be used for all other parts and
attachments.
1 Switch o the appliance.
2 Detach the shaving head from the appliance (see
'Detaching and attaching the shaving head').
3 Remove the cutting unit from the shaving head (see
'Detaching and attaching the cutting unit of shaving
head'). Clean the hair chamber with the brush.
4 Rinse the cutting unit and the shaving head under
the tap (Fig. 16).
5 Carefully shake o excess water and let all parts air
dry completely.
Storage
Note: Do not place or store the appliance where it can
fall or be pulled into a tub or sink, water or other liquid
while plugged in.
- Make sure that the appliance is switched o and
that the USB supply unit has been removed from the
wall socket and from the appliance.
- Do not wrap the USB cable around the appliance
when storing.
- Attach a shaving comb onto the shaving head to
protect the cutting unit during storage.
Assistance
For all product support, please visit www.philips.com/
support.
Ordering accessories
To buy accessories or spare parts, visit www.philips.
com/parts-and-accessories or go to your Philips
dealer. You can also contact the Philips Consumer Care
Center in your country (see the international warranty
leaet for contact details).
The following accessories are available:
- Cutting unit of shaving head: model BG2010/43.
Replacement
Replacing the cutting unit of shaving head
For maximum shaving performance, we advise you
to replace the cutting unit of shaving head every year
(model BG2010/43).
If the the cutting unit is worn or damaged, do not
use the appliance and replace it immediately. Always
replace the cutting unit of shaving head with the
original Philips accessory.
1 Switch o the appliance and disconnect it from the
power outlet.
2 Remove the cutting unit from the shaving head by
pulling it o the appliance.
3 Place the new cutting unit onto the shaving head by
snapping it into place. You will hear a click.
4 After replacing the cutting unit, make sure that the
shaving head is rmly attached before using the
appliance.
Removal of built-in rechargeable
battery
The built-in rechargeable battery must be removed
when the appliance is discarded. Before removing the
battery, make sure that the appliance is disconnected
from the wall socket and that the battery is completely
empty.
Take any necessary safety precautions when you
handle tools to open the appliance and when
you dispose of the rechargeable battery.
When you handle batteries, make sure that your
hands, the product and the batteries are dry.
To avoid accidental short-circuiting of batteries
after removal, do not let battery terminals
come into contact with metal objects (e.g.
coins, hairpins, rings). Do not wrap batteries in
aluminum foil. Tape battery terminals or put
batteries in a plastic bag before you discard
them.
1 Detach the shaving head from the handle (Fig. 7).
2 Use a athead screwdriver to lift up the head
interface key (Fig. 17).
3 Insert a athead screw into the cavity at the front of
the handle. Then lift and remove the head interface
module (Fig. 18).
4 Insert a athead screwdriver underneath the driving
spindle and pull out the inner tube from the handle
(Fig. 19).
5 Use the athead screwdriver to undo the six snap
connections holding the printed circuit board in the
frame (Fig. 20).
6 Remove the printed circuit board including the
battery (Fig. 21).
7 Detach the battery from the printed circuit board
(Fig. 22). You can now dispose of the rechargeable
battery.
Recycling
- This symbol means that electrical products and
batteries shall not be disposed of with normal
household waste (Fig. 23).
- Follow your country’s rules for the separate
collection of electrical products and batteries.
English
Bekijk gratis de handleiding van Philips BG3470, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Philips |
| Model | BG3470 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2813 MB |
