Handleiding
Je bekijkt pagina 32 van 64
• Standard - Speakers output follow the original
channels.
• Surround AI - Optimum surround effect using AI
analysis.
DRC
Settings > Sound > EasyLink 2.0 > DRC.
Select the preferred Dynamic Range Control (DRC).
• Auto - Dynamic range is automatically adjusted.
• On - Optimize the dynamic range.
• Off - Turn off dynamic range adjustment.
Height speakers
Settings > Sound > EasyLink 2.0 > Height
speakers.
Select the preferred height speakers movement.
• Auto - Dynamic movement follow contents.
• On - Always elevated.
• Off - Flat position.
Select sound stage
Settings > Sound > EasyLink 2.0 > Sound stage.
Select a listening experience.
• Auto - Dynamic setting follow contents.
• On - Immersive Sound Stage, good for watching
movies.
• Off - Crystal Sound Stage, good for listening to
music and dialogue.
Reset all to default
Settings > Sound > EasyLink 2.0 > Reset all to
default.
Reset all the EasyLink 2.0 sound settings back to the
original factory settings.
Room Calibration
Room calibration
Settings > Sound > Room calibration.
This calibration will allow the display to determine
the acoustics in your room and provide optimized
sound quality on the display speakers that best
match the acoustics.
You need to pair your remote control with
the display before starting the setup and make sure
the display Audio out setting is Display
speakers. For a more accurate result, please keep the
room quiet.
To start the room calibration…
1 - Hold your remote control at the listening position
and point it towards the display during the tuning
process.
2 - Select Calibrate now or Calibrate again to start
the calibration.
3 - A test sound will be played and measured
through your remote control. Hold your remote
control and point it towards the display, this can take
several seconds.
4 - Once your display speakers are successfully
calibrated, select Test to listen to the sound before
and after the display speakers are calibrated. Select
Apply to accept the setting or select Try again to redo
the calibration.
5 - When room calibration setup is successful and
applied, the display shall return to the Settings menu.
Now go to Settings > Sound > Room calibration
and select Apply calibration to tune the audio output
from display speakers.
Advanced Sound Settings
Volume Control
Auto volume
Settings > Sound > Advanced > Auto volume.
Select On or Off to switch on or off the auto volume
adjustment.
Select Night Mode for a more comfortable quiet
listening experience.
Delta volume
Settings > Sound > Advanced > Delta volume.
The Delta volume setting can be used to adjust to
balance the sound level difference between the
programme and the HDMI source input. Press the
arrows (up) or (down) to adjust the delta
value for display speaker volume.
* Note: Delta volume is available when the input
source is set to HDMI or Analogue sources and the
Audio out is set to TV speakers or HDMI sound
system.
Audio Out Settings
Audio out
Quick Menu > Frequent Settings > Audio out.
Set the TV to play the sound on TV or on the
connected audio system.
32
Bekijk gratis de handleiding van Philips 86PUH8807, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Philips |
| Model | 86PUH8807 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 7008 MB |
