Handleiding
Je bekijkt pagina 4 van 176
ecitoN
scitsiretcarahc lexiP
-ceffe sah ti hguohtlA .slexip roloc fo rebmun hgih a sah tcudorp DCL sihT
tive pixels of 99.999% or more, black dots or bright points of light (red,
green or blue) may appear constantly on the screen. This is a structural
property of the display (within common industry standards) and is not a
malfunction.
ytnarraW
ot srevoc evomer ro nepo ton oD .elbaecivres resu era stnenopmoc oN
the inside of the product. Repairs may only be done by service centers
and ożØÿ½ērepair shops. Failure to do so shall void any warranty, stated or
implied.
ro stnemtsujda yna ,launam siht ni detibihorp ylsserpxe noitarepo ynA
assembly procedures not recommended or authorized in this manual shall
void the warranty.
eciton noissimmoc snoitacinummoc laredeF
stimil eht htiw ylpmoc ot dnuof dna detset neeb sah tnempiuqe sihT
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits ar
e designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipmentġŻ½ĚÞ on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit diŻerent from that to
which the receiver is connected.
Consult the dealer or an experienced radio or television technician for
help.
snoitacifidoM
ro segnahC .ygrene ycneuqerf oidar esu ro etareneg yam sutarappa sihT
modižcations to this apparatus may cause harmful interference.
-rohtuanu na fi sutarappa siht etarepo ot ytirohtua eht esol dluoc resu ehT
ized change or modižcation is made.
selbaC
-latem htiw selbac dedleihs htiw edam eb tsum ecived siht ot snoitcennoC
lic RFI/EMI connector hoods to maintain compliance with FCC Rules and
regulations.
eciton naidanaC
)B( 3-BMN/)B( 3-SECI NAC
Analog and digital television receiving apparatus, Canada BETS-7/
NTMR-7.
NAL sseleriw eht ot seilppa SSR CI/CCF gniwollof ehT
adapter included in this product.
-pa ylsserpxe ton snoitacifidom ro segnahc ynA :noituac CCF
proved by the party responsible for compliance could void the
user’s authority to operate this equipment.
noitcnujnoc ni detarepo ro detacol-oc eb ton tsum rettimsnart sihT
with any other antenna or transmitter.
ecnailpmoC erusopxE FR CI/CCF
tes stimil erusopxe noitaidar CI/CCF htiw seilpmoc tnempiuqe sihT
forth for an uncontrolled environment and meets the F
CC radio
frequency (RF) Exposure Guidelines and RSS-102 of the IC radio
frequency (RF) Exposure rules.
This equipment should be installed and operated keeping the radia-
tor at least 20cm or more away from your body.
-naC yrtsudnI dna seluR CCF fo 51 traP htiw seilpmoc ecived sihT
ada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interfer-
ence, and (2) this device must accept any interference, including
interference that may cause undesired operation of this device.
.ylno snoitarepo roodni ot detcirtser si dnab zHM 0525-0515
-su ytiroirp .e.i( sresu yramirp sa detacolla era sradar rewop-hgiH
ers) of the bands 5250-5350 MHz and 5650-5850 MHz and that
these radars could cause interference and/or damage to LE-LAN
devices.
CI dna )c(704.51 tnemeriuqer CCF htiw ecnailpmoC
requirement RSS-210 A9.4.4
eht si hcihw ,erawtfos yb detaitini syawla si noissimsnart ataD
passed down through the MAC, through the digital and analog
baseband, and žĚ½ēēŮŊġ the RF chip. Several special packets are
initiated by the MAC. These are the only ways the digital baseband
portion will turn on the RF transmitter, which it then turns oŻat
the end of the packet. Therefore, the transmitter will be on only
while one of the aforementioned packets is being transmitted. In
other words, this device automatically discontinue transmission in
case of either absence of information to transmit or operational
failure.
Trademarks are the property of Koninklijke Philips N.V. or their respective owners.
Skyworth USA Corporation reserves the right to change products at any time with-
out being obliged to adjust earlier supplies accordingly.
The material in this Owner’s manual is believed adequate for the intended use of the
system. If the product or its individual modules or procedures are used for purposes
other than those specified herein, confirmation of their validity and suitability must be
obtained. Skyworth USA Corporation warrants that the material itself does not
infringe any United States patents. No further warranty is expressed or implied.
Skyworth USA Corporation cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result of the content in this
document. Errors reported to Skyworth USA Corporation will be adapted and
published on the Skyworth USA Corporation support website as soon as possible.
!"# $% &'(')*+'% ", +% +-. *//*0*+1, $1,+ 2. *//0%3.& 2# 45#6%+-
8%0/%0*+'%"9
74!
Bekijk gratis de handleiding van Philips 65OLED974, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Philips |
| Model | 65OLED974 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 24835 MB |
