Philips 5000 Series 24B2G5200 handleiding

Monitor

Philips

35 pagina's

PDF beschikbaar

Handleiding

11. Troubleshooting &

FAQs

11.1 Troubleshooting

This page deals with problems that can

be corrected by a user. If the problem

still persists after you have tried these

solutions, contact Philips customer service

representative.

Common Problems

No Picture (Power LED not lit)

• Make sure the power cord is plugged

into the power outlet and into the

back of the monitor.

• First, ensure that the power button

on the front of the monitor is in the

OFF position, then press it to the ON

position.

No Picture (Power LED is White)

• Make sure the computer is turned on.

• Make sure the signal cable is properly

connected to your computer.

• Make sure the monitor cable has no

bent pins on the connect side. If yes,

repair or replace the cable.

• The Energy Saving feature may be

activated

Screen says

Check cable connection

• Make sure the monitor cable

is properly connected to your

computer. (Also refer to the Quick

Start Guide).

• Check to see if the monitor cable has

bent pins.

• Make sure the computer is turned on.

AUTO button doesn't function

• The auto function is applicable only

in VGA-Analog mode. If the result is

not satisfactory, you can do manual

adjustments via the OSD menu.

Note

The Auto Function is not applicable in

DVI-Digital mode as it is not necessary.

Visible signs of smoke or sparks

• Do not perform any troubleshooting

steps

• Disconnect the monitor from mains

power source immediately for safety

• Contact with Philips customer service

representative immediately.

Imaging Problems

Image is not centered

• Adjust the image position using

the “Auto” function in OSD Main

Controls.

• Adjust the image position using the

Phase/Clock of Setup in OSD Main

Controls. It is valid only in VGA mode.

Image vibrates on the screen

• Check that the signal cable is properly

securely connected to the graphics

board or PC.

Vertical icker appears

• Adjust the image using the “Auto”

function in OSD Main Controls.

• Eliminate the vertical bars using the

Phase/Clock of Setup in OSD Main

Controls. It is valid only in VGA mode.

Horizontal icker appears

Bekijk gratis de handleiding van Philips 5000 Series 24B2G5200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.