Handleiding
Je bekijkt pagina 18 van 55
4 Use your TV
Switching on your TV and putting it in
Standby mode
Remote Control
TV
T
To Turn the TV On from Standby or Off to Standby
•
Press on the Side panel or the Remote Control.
Note(s)
•
Energy Consumption contributes to air and water pollution. When the AC Power Cord is plugged
in, your TV consumes energy with a very low Standby Power Consumption.
Adjusting Volume
Remote Control
TV
To decrease or increase Volume
•
Press VOL/ on the Side panel or press VOL + / – on the Remote
Control.
VOL (–) : Volume Down
VOL (+) : Volume Up
To mute or unmute sound
•
Press on the Remote Control to mute the sound.
•
Press again or VOL + / – to recover the original sound.
Switching Channels
Remote Control
TV
To Select Channels by using CH / or CH + / –
•
Press CH (Up) / (Down) on the side panel or press CH + / – on the
Remote Control.
To Select Channels by using the NUMBER buttons
Digital TV Operation
•
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–When selecting Digital channel 1 1. 1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–When selecting Cable or Analog channel 1 1
Press PREV.CH to return to the previously viewed channel.
Note(s)
•
To Select the non-memorized channels, use the NUMBER buttons.
•
Channel not available or No signal will appear on the TV screen after the subchannel broadcast
is over.
•
Audio only message will appear on the TV screen, when you receive only sound signal.
18 .English
Continued on next page.
Bekijk gratis de handleiding van Philips 40PFL4911, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Philips |
| Model | 40PFL4911 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 8873 MB |
