Philips 1000 Series 24E2N1100LB handleiding

Monitor

Philips

31 pagina's

PDF beschikbaar

Handleiding

Note

• MPRT: To reduce motion blur, LED

backlight will strobe synchronously

with screen refresh, which may cause

noticeable brightness change.

• 75Hz refresh rate or higher is

required for MPRT.

• Adaptive Sync and MPRT cannot be

enabled simultaneously.

• MPRT is to adjust brightness for

blur reduction, so cannot adjust

brightness while MPRT is turned on.

• MPRT is gaming-optimized mode.

Turn on MPRT may cause noticeable

screen flickering. It is recommended

to turn off when you are not using

the gaming function.

Resolution notication

This monitor is designed for optimal

performance at its native resolution,

1920 x 1080. When the monitor is

powered on at a dierent resolution, an

alert is displayed on screen: Use 1920 x

1080 for best results.

Display of the native resolution alert can

be switched o from Setup in the OSD

(On Screen Display) menu.

Overclock Your Monitor

The Overclock function increases the

native refresh rate, however, it does

have some associated risks along with it.

Please follow the instructions below to

activate the Overclock feature on your

monitor:

1. First, check your PC’s graphics card

and make sure it is capable of

achieving the maximum resolution

and refresh rate of this monitor.

2. If needed, install the latest version of

graphics card driver.

3. Ensure the Overclock signal port is

available (Please refer to the chapter

Resolution & Preset Modes in the

dedicated user manual).

4. Modify the refresh rate in the On

Screen Display (OSD) settings.

To enable the Overclock feature, you will

need to go to OSD menu > Game Setting

> Overclock.

 













 





 

24E2N1100

 







 

 





24E2N1101B

 









Note

Please note that the default setting

for Overclock is o as it can cause

irreversible damage to your monitor.

If the screen is displayed abnormally

after rebooting, please switch o

the Overclock setting located in the

monitor's OSD menu. Alternatively, you

can unplug the power cable. Then, press

and hold the left button of the menu

toggle on the monitor while plugging

the power cable back in. Keep holding

the button until the screen turns on.

This will turn o the Overclock function,

and the monitor will return to its default

refresh rate.

Bekijk gratis de handleiding van Philips 1000 Series 24E2N1100LB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.