Petsafe ScoopFree PAL19-14656 handleiding

Niet gecategoriseerd

Petsafe

65 pagina's

PDF beschikbaar

Handleiding

www.petsafe.net

ENES FRIT NLDE

LED Indicator Light

The LED Indicator Light is located on top of the Litter Box. It tells you the status of the Litter Box and can help you diagnose potential problems.

Function Indicator Light Rake/Action

Litter Box is on Solid green Rake is in Home position

Detection Sensors are triggered by a cat in the Litter Box Flashes green 4 times per second Rake is in Home position

Cat has left the Litter Box Flashes green once per second Rake Delay countdown is activated

Rake Delay countdown complete Flashes green once per second Automatic raking is in process

Obstruction or interruption Flashes green 8 times per second Refer to the “Troubleshooting” section for solutions

STEP 2

Install the Litter Tray

1. Place the Litter Tray cover under the Litter Tray (A). The cover is extra protection against leaks and

will be used later fordisposal.

2. Record Today’s Date of Litter Tray installation and Tray Change Date on the Waste Compartment

label. See the Recommended Litter Tray Replacement chart in the “Changing the Litter Tray” section

to determine the Tray Charge Date.

Note: Using a Litter Tray longer than the recommended period may result inleakage.

3. Lift the Litter Box Frame at the Waste Compartment Lid until it is standing on its end.

4. Position the Litter Tray below the Litter Box Frame. Ensure the Waste Compartment is below the

Waste CompartmentLid(B).

5. Lower the Litter Box Frame onto the Litter Tray (C). You should hear a click conﬁrming the magnets

on the Waste Compartment Lid have connected to the Magnet Contacts on the Litter Tray Waste

Compartment(D). Ensure the Litter Box Frame is level and sitting on the LitterTray.

6. Open the bag of Crystal Litter by tearing the corner notch. Pour litter into the tray (E). Spread the

litter evenly, but do not put litter under the Waste Compartment. Discardbag.

7. Ensure the LED Indicator Light is on solid green. If ﬂashing, level out the litter so that it is not

blocking the Detection Sensors.

STEP 3

Install the Privacy Hood

The removable Privacy Hood adds more privacy for your cat along with better litter containment and odour control for you..

1. Place the posts on the bottom of the Privacy Hood into the holes on the top of the Litter Box (A).

2. Insert the posts at the back of the Litter Box ﬁrst and then the front. The Privacy Hood should ﬁt snuggly

into all fourholes.

Back

Front

“Click”

Bekijk gratis de handleiding van Petsafe ScoopFree PAL19-14656, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.