Perel LEDS12CWW handleiding
Handleiding
Je bekijkt pagina 6 van 39
LEDS12CWW
V. 03 – 22/11/2017 6 ©Velleman nv
5. Remote Control Overview
Refer to illustration [B2] on page 3 of this manual.
1
on/off
2
reset cold and warm white to 100 % intensity
3
colour temperature adjustment
4
quick colour temperature adjustment
5
dimming
6
cold and warm white flash function
7
speed setting
6. Installation
Guidelines
Avoid installing the LED strips near heat sources such as ovens,
toasters, etc.
Never use the LED strip when it is coiled up as this can cause
overheating.
Before mounting, ensure the desired surface is flat and clean of
any grease, dirt or debris.
Avoid tight bends in the LED strip.
Observe the correct polarity when re-joining cable sections. The
polarity is marked at regular intervals along the LED strip.
Cut the strip using sharp scissors or a craft knife with a fresh
blade. Cut directly on the marked line. Never cut the LED strip
when it is pugged in.
Installation
Refer to the illustrations on page 2 of this manual.
1. Mount the LED strip in the desired location. The LED strip can be
cut every 10 cm (see [A1]). Protect the cut ends to avoid short-
circuits.
2. Connect the LED strips to the controller (see [A2]). Make sure
to connect matching wire colours and do not short-circuit any
wires. Connecting tools are not included.
Bekijk gratis de handleiding van Perel LEDS12CWW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Perel |
| Model | LEDS12CWW |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 3146 MB |
