PAX Passad 30 handleiding
Handleiding
Je bekijkt pagina 14 van 36
EN – For the installer
14
User and installation guide
Preparations
Push the two locking buttons towards the centre (A1) and lift the motor unit
out of the frame. Then remove the motor unit (A2).
Unscrew screw B1 and remove the housing from the frame.
The terminal block (B2) is behind the frame.
Add this to the side until the frame is attached to the structure.
Installing the seal and cable gland
The seal supplied is in three parts: gasket (C1), cu (C2) and cable gland
(C3). Separate these from each other.
Install the gasket on the back side of the housing (D1). Note that the gasket
also serves as a bushing for the screws. For a concealed electrical con-
nection, install the cable gland in one of the three knockout openings (D2).
The cable gland must be used for surface electrical connection as well.
For this, a breakaway section in the housing must be removed (E).
The cu is designed to provide a seal with a Ø100 mm tube (see Figure F).
Installation
B1
B2
A1
A2
C1
C2
D2
D1
F
E
C3
Bekijk gratis de handleiding van PAX Passad 30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | PAX |
| Model | Passad 30 |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 4248 MB |
