Parmco WM10WF03 handleiding
Handleiding
Je bekijkt pagina 11 van 21
Installation
Use process
Installation
Use process
Installation place requirement
A concrete floor is the most suitable installation surface
for a washing machine, being far less prone to vibration
during the spin cycle than wooden floorboards or carpeted
surface.
The machine must be level and securely positioned. The
distance between the machine and wall must be more than
10 cm .
To avoid vibrations during spinning. the machine should not
be installed on soft floor coverings.
Level adjustment
The machine must stand perfectly level on all four feet to
ensure safe and proper operation.
Incorrect installation may increase electricity and water
consumption and may cause the machine to move about.
To do these when the machine is not level:
Using the spanner turn locknut in a anticlockwise direction.
Then turn locknuts together with adjust feet to unscrew.
Use a spirit level to check the machine is standing level.
Hold adjust feet securely with a pipe wrench. Turn locknut
again using the spanner until it sits firmly up against the
housing.
Vibration and noise may occur if the locknuts do
not sit firmly up against the houses.
Drain hose connection
1.Direct into a sink
If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in
the drain hose to prevent waste from the sink entering the washing machine.
If required,the drain hose can be extended to a length of 4 m.
2. Connected securely to a standpipe
Firstly form a hook in the end of the drain hose using the “U” piece supplied.
Place the drain hose into your standpipe, which should have an internal diameter of approximately
38mm thus ensuring there is an air break between the drain hose and standpipe.
When discharging into a standpipe ensure that the top fo the standpipe is no more than 90cm and
no less than 60cm above floor level.
Water inlet connection
Locknuts
Adjustable feet
1. Connect the inlet hose to the machine.
2. Connect the inlet hose to a tap with 3/4" thread.
Do not use previously employed hoses.
Installation should comply with local water authority and building regulations’ requirements.
Bekijk gratis de handleiding van Parmco WM10WF03, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parmco |
| Model | WM10WF03 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 1767 MB |
