Handleiding
Je bekijkt pagina 15 van 36
13
a suitable isolating switch providing full disconnection from the mains
power supply is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air
gap contact separation in all poles (or in all active [phase] conductors if
the local wiring rules allow for this variation of the requirements). The
isolating switch will be easily accessible to the customer with the hob
installed.
you consult local building authorities and by-laws if in doubt regarding
installation.
you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for
the wall surfaces surrounding the hob.
The power cable must not come into contact with cabinet doors or
drawers.
The appliance must be supplied with an adequate flow of fresh air from
outside the
cabinet to the base of the hob.
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do
not apply force onto the controls protruding from the hob.
Stretch out and stick the supplied tape [02] along the underside edge of the hob,
ensure the ends overlap. Trim off any excess tape and dispose of it.
locating the fixing brackets
Fix the hob brackets by screw two brackets on the bottom of hob (see picture).
Bekijk gratis de handleiding van Parmco HO16AC4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parmco |
| Model | HO16AC4 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3047 MB |
