Parkside PZKS 2000 C3 handleiding
Handleiding
Je bekijkt pagina 22 van 84
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of separately!
• Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be
removed non-destructively before disposal! Their dis-
posal is regulated by the battery act.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their person-
al data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
– Public disposal or collection points (e.g. munici-
pal works yards)
– LIDL offers you return options directly in the
shops and markets. Return and disposal are free
of charge.
– Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a
new device from the manufacturer or taken to
another authorised collection point in your vicini-
ty.
– Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to aprivate household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer’s customer service for this.
• These statements only apply to devices installed and
sold in the countries of the European Union and
which are subject to the European Directive
2012/19/EU. In countries outside the European
Union, different regulations may apply to the dispos-
al of waste electrical and electronic equipment.
18 Troubleshooting
Fault Possible cause Remedy
Motor does not work Engine, cable or connector defective,
mains fuses blown.
Arrange for inspection of the machine by a spe-
cialist. Never repair the motor yourself. Danger!
Check mains fuses and replace as necessary
The engine runs slowly and
does not reach the operating
speed.
Voltage too low, coils damaged, ca-
pacitor burnt.
Have an electrician check the voltage. Arrange
for inspection of the motor by a specialist. Ar-
range for replacement of the capacitor by a spe-
cialist.
Engine producing excessive
noise.
Coils damaged, motor defective. Arrange for inspection of the motor by a special-
ist.
The engine does not reach
full power.
Circuits in the network are overload-
ed (lamps, other motors, etc.).
Do not use any other equipment or engines on
the same circuit.
Motor overheats easily. Overloading of the motor, insufficient
cooling of the motor.
Avoid overloading the motor while cutting, re-
move dust from the motor in order to ensure op-
timal cooling of the motor.
Saw cut is rough or wavy. Saw blade dull, tooth shape not ap-
propriate for the material thickness.
Resharpen saw blade and/or use suitable saw
blade.
Workpiece pulls away and/
or splinters.
Excessive cutting pressure and/or saw
blade not suitable for use.
Insert suitable saw blade.
16 |
GB / IE / NI
Bekijk gratis de handleiding van Parkside PZKS 2000 C3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PZKS 2000 C3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11378 MB |
