Parkside PWD 30 C1 handleiding
Handleiding
Je bekijkt pagina 21 van 44
19GB/IE/NI
Fig.J
1. Unlock the latches
[8] by pulling them away
from the metal container
[].
2. Lift up the latches
[8] and disconnect them
from the rib
[].
3. Reverse above steps to lock the container
lid
[2] on the metal container[].
Fig.K, L
1. Hold the carry handle
[1] and remove the
container lid
[2] from the metal container[].
2. The filter basket
[] is exposed for filter
installation or replacement.
3. Fold down the carry handle
[1] after use and
before storing the product.
Installing the filter
m
CAUTION!
u Never vacuum without a filter installed to
the product. Sucked in substances may
contain metal or hard, sharp particles,
which may damage the motor or cause an
electric shock. Dust would be blown out
from the blow connector
[] at a very high
speed which could cause serious personal
injury.
u Only vacuum liquids with the pleated
filter
[] installed to the product. Otherwise
the product will be damaged. The paper
filter bag
[] will also be damaged, if you
use it for wet vacuuming.
NOTE
u The paper filter bag
[] is suitable for dry
vacuuming only.
u Do not use the pleated filter
[] for
vacuuming very fine dust or dirt (e.g.
sanding dust). The pleated filter can be
used for many other materials though.
Pleated filter
Fig.M
NOTE
u Before installing pleated filter
[], ensure
the lever
[] is unlocked.
1. Turn the container lid
[2] over.
2. Install the pleated filter
[] to the filter
basket
[].
3. Insert the pleated filter
[] until the bottom
side of the pleated filter touches the surface of
the filter basket
[].
4. Turn the lever
[] to lock the pleated filter[]
in place.
5. Pull the pleated filter
[] slightly without
movement, to check if the pleated filter is
installed properly.
NOTE
u If the pleated filter
[] does not lock in
place: Turn the pleated filter slightly without
force, until the inside lock is sitting in place
with the filter basket
[]. Turn the lever to
lock the pleated filter in place.
Paper filter bag (dry vacuuming)
Fig.N
1. Turn the container lid
[2] over.
2. Align the hole of the paper filter bag
[] with
the internal suction connector
[].
3. Press down the paper filter bag
[] to insert
the internal suction connector into the hole of
the paper filter bag.
4. Press down the paper filter bag
[] until the
seal ring
[] is fitted into the circular rib[].
Bekijk gratis de handleiding van Parkside PWD 30 C1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PWD 30 C1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7379 MB |
