Parkside PSTDA 20-Li C3 handleiding
Handleiding
Je bekijkt pagina 15 van 64
GB
IE
NI
15
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (29) from the
device.
2. Push the battery (29) into the charging
slot of the battery charger (28).
3. Connect the battery charger (28) to a
power outlet.
4. After charging, disconnect the battery
charger (28) from the mains.
5. Pull the battery (29) out of the battery
charger (28).
Control LEDs on the charger (28):
greenredMeaning
lights up—• Battery is fully
charged
• stand-by (No
battery inserted)
—lights upBattery is charging
—flashesBattery is over-
heated
flashesflashesBattery is defective
Operation
Information on sawing
General Information
With this order, you work safely with the
sabre saw and achieve a good result:
1. Clamp the workpiece. Use a clamping
device for small workpieces.
2. Draw a line to specify the direction in
which the saw blade is guided.
3. Hold the device securely by the
handle.
4. Set the mitre angle.
5. Set the stroke strength.
6. Turn the device on.
7. Wait until the device has reached its
full stroke rate.
8. Place the footplate on the workpiece.
9. Slowly move the device along the
marked line, pressing the footplate
firmly down onto the workpiece.
10. Do not apply too much pressure in the
cutting direction. Let the device do the
work.
11. Before shutting down the device, switch
it off and wait for it to come to a com-
plete standstill.
Selecting the pendulum motion
The larger the pendulum motion, the faster
your progress.
The optimal pendulum motion can be es-
tablished through practice; the following
settings are recommended:
• For thin material, hard material (e.g.
metal) or for cutting curves: Level 0
• Fine and clean cutting edges can be
achieved with little or no pendulum mo-
tion: Level 0 or 1.
• Soft material (wood, plastic, etc.): level
2 or 3
Plunge sawing
Requirements
• Soft materials such as wood, aerated
concrete, plasterboard etc.
• Mitre angle: 0°
• Short saw blade mounted
Procedure (Fig.F)
1. Place the device with the front edge of
the footplate (11) on the workpiece.
The saw blade (16) does not touch the
workpiece.
2. Turn the device on. Wait until the max-
imum stroke rate has been reached.
Bekijk gratis de handleiding van Parkside PSTDA 20-Li C3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PSTDA 20-Li C3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2114 MB |
