Parkside PSS 65 D1 handleiding
Handleiding
Je bekijkt pagina 17 van 56
14 GB/IE/NI/CY
11. Remove the drill holder
[] and insert it into
the rotatable drill mount
[] by rotating in
by 180°. Using the same adjustment, you
can grind the opposite cutting edge of the
drill.
12. Switch the device on and grind the drill.
13. Switch the device off and wait for the
grinding wheel
[] to stop.
[C] Sharpening picks and chisels
1. Mount the selected sharpener (see
Mounting sharpener).
2. Place the blade on the tool table
[6] so that
it lies against the spacer
[4]. The magnetic
holder
[5] keeps the blade in position.
3. Release the retaining screw for the angular
adjustment
[7] and turn the tool table [6]
into position. Select the angle according
to the existing bevel angle (angle of the
bevelled edge).
4. Tighten the retaining screw for angular
adjustment
[7] again.
5. Switch the device on and move the tool
table
[6] equally back and forth along the
grinding wheel
[].
6. Always use light pressure while sharpening
and slowly push the blade towards the
grinding wheel
[].
7. Repeat the sharpening process until all
irregularities have been removed.
8. Switch the device off and wait for the
grinding wheel
[] to stop.
NOTE
u To sharpen a chisel, turn the chisel over
and repeat the process from Point 5.
[D] Sharpening knives
m
CAUTION!
Wear safety gloves when
handling knives and scissors.
NOTE
u The device is not suitable for grinding
serrated knives.
1. Mount the selected sharpener (see
Mounting sharpener).
2. Turn the machine on.
3. Insert the blade of the knife right into the
grinding slot.
4. Using light pressing guide the blade along
the grinding wheel
[] and evenly and
slowly pull the knife towards you.
5. Turn the knife and insert the knife blade into
the opposite grinding slot.
6. Repeat this grinding process for this side of
the blade as well.
7. Execute the alternating grinding process
until the cutting edge is burr-free and sharp.
8. Switch the device off and wait for the
grinding wheel
[] to stop.
[E] Sharpening scissors
NOTE
u The device is not suitable for grinding
serrated scissors. The device is not
suitable for grinding pinking shears.
1. Mount the selected sharpener for knives
and scissors
[1] (see Mounting sharpener).
2. Completely open the scissors.
3. Turn the machine on.
4. Insert one of the scissor blades into the
grinding slot.
5. Using light pressure guide the blade from
the screw up to the tip along the grinding
wheel
[].
Bekijk gratis de handleiding van Parkside PSS 65 D1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PSS 65 D1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5685 MB |
