Parkside PSBSA 20-Li D4 handleiding
Handleiding
Je bekijkt pagina 11 van 163
PSBSA 20-Li D4
GB
│
IE │ 7 ■
♦ Push the battery pack back into the appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch into
the middle position (lock). Allow the battery
pack to click into the handle.
Removing the battery pack:
♦ Press the release button and remove the
battery pack.
Checking the battery charge level
♦ Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the additional handle
♦ Screw the additional handle onto the left or
right of the appliance depending on how you work.
Changing tools
Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is stopped, the power train locks
so that the chuck
can be opened by turning
it . Once you have attached the desired tool
and tightened it by turning the chuck , you can
continue working. The spindle lock is automatically
released when the motor starts (ON/OFF
switch pressed).
Torque preselection/selecting the
operating mode
You can adjust the torque on the torque prese-
lector
and select between the drill setting
and the hammer drill setting
.
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or removing screws.
♦ Select the drill setting for drilling work by adjusting
the torque selection ring to the position
.
♦ Select the hammer drill setting for hammer
drilling work by adjusting the torque selection
ring to the position
.
2-speed gearbox
CAUTION!
► Operate the speed selection switch only
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear (speed selector switch
in
position: 1)
you can reach a speed of approx. 440 rpm and a
high torque. This setting is suitable for all screwing
work but also for the use of accessories.
In second gear (speed selector switch in
position: 2)
you can reach a speed of approx. 1650 rpm for
carrying out drilling work.
Use
Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in.
The LED work light lights up when the ON/OFF
switch is depressed lightly or fully. This allows
for illumination of the work area in low lighting.
Switching off:
♦ Release the ON/OFF switch to switch off the
appliance.
Adjusting the rotational speed
Press the ON/OFF switch lightly for a low
speed. Increasing the pressure increases the speed.
NOTE
►
The integrated motor brake ensures rapid
stoppage.
Bekijk gratis de handleiding van Parkside PSBSA 20-Li D4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PSBSA 20-Li D4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19187 MB |
