Parkside PPS 30 C2 handleiding
Handleiding
Je bekijkt pagina 20 van 45
20 GB/IE/NI
ATTENTION!
fTo unscrew the electrode, do not apply
irregular pressure, gradually increase
pressure until the electrode comes out.
Then screw the new electrode into the
holder.
The burner sleeve
8c
must be replaced if
the central bore is damaged or if it has
expanded in comparison to the bore of a
new nozzle. If the electrode
8d
or the
burner sleeve
8c
are replaced too late,
this can result in the parts overheating.
Once replaced, make sure the nozzle
clamping sleeve
8b
is tightened
sufficiently.
ATTENTION!
fThe nozzle clamp sleeve
8b
must only
be screwed on to the burner
8
once it
has been fitted with the electrode
8d
and
burner sleeve
8c
.
fIf these parts are missing,
the device may malfunction and
it may create a hazard for the
operating personnel.
• Maintenance
PLEASE NOTE!
fThe plasma cutter must be regularly
maintained for perfect function and to
comply with the safety requirements.
Improper and wrong operation may
cause failures and damage to the
device. Repairs must only be carried out
by qualified specialists.
PLEASE NOTE!
fIt is not necessary to empty the conden-
sation water container
18
. If water
collects here then fine droplets will form
under the container. The condensation
water is then dissipated through
evaporation.
Switch off the main power supply and the
main switch of the device prior to carrying
out maintenance or repair work on the
plasma cutter.
Regularly clean the outside of the
plasma cutter and its accessories. Use
compressed air, cotton waste or a brush
to remove dirt and dust.
In case of a defect or a necessary
replacement of equipment parts, please
contact the appropriate qualified
personnel.
• Storage
If you will not be using the device for a
while, protect it from dust by storing it in
aclean and dry place.
• Information about recycling
and disposal
DO NOT DISPOSE OF
ELECTRICAL TOOLS IN HOUSEHOLD
WASTE! DON’T THROW AWAY –
RECYCLE! According to European Directive
2012/19/EU, used electrical devices must
be collected separately for environmentally
compatible recycling or recovery. The
symbol of the crossed out dustbin means that
this device must not be disposed of in
household waste at the end of its service life.
The device must be handed in at established
Bekijk gratis de handleiding van Parkside PPS 30 C2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PPS 30 C2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5015 MB |
